Operating Manual

POWER JUICER ELITE
Assembly/Main Unit
9
Main Unit
STEP 9:
Insert pusher into chute. Always use
pusher to feed fruits and vegetables
into unit. Push gently, never force.
The blade will do the work.
WARNING: WHEN JUICING
CHERRIES MAKE SURE THE POWER
IS OFF AND BLADE HAS STOPPED
SPINNING BEFORE REMOVING
THE PUSHER FROM
THE CHUTE.
STEP 8:
Lock lid into place by lifting locking
bar up until it clicks into grooves
located on both sides of the lid.
Make sure locking bar is in the full
upright, locked position.
IMPORTANT: The unit will not start until this bar
is properly locked in place.
STEP 7:
Make sure juice spout is
in the downward position.
If the juice spout is left
in the upright position
the juice will not flow.
It will stay in the
receptacle and may
overflow from the sides.
DOWNWARD POSITION
UPRIGHT POSITION
POWER JUICER ELITE
8
Assembly/Main Unit
STEP 4:
Place blade inside filter, centered
over screw peg. Using orange
crescent tool, place its pegs
into the holes on the blade.
Turn clockwise while holding
the filter and receptacle in place
until tight (as shown).
STEP 6:
Place lid with built-in pulp guard on top
of receptacle, making certain it is snugly
aligned with the pulp guard facing in
the opposite direction of the juice spout.
STEP 5:
Place the pulp collector so that it rests
under the backside of the juicer.
POWER JUICER ELITE
IMPORTANT: There are MIN/MAX arrow markings on the
orange rim of the filter. These markings prevent you from
overtightening or undertightening the blade. Crescent
tool should line up between MIN/MAX arrows (as shown).
CAUTION: Remove crescent tool and set
aside. Do not leave tool inside juicer.
Note: Refer to page
6 for all part names.
Note: Refer to page
6 for all part names.
Main Unit
Micro
Safetyswitch
Assembly
Assembly
MIN/MAX
Arrow Markings
Filter
Crescent Tool
Micro
Safetyswitch
IMPORTANT: There is a Micro Safetyswitch located
in the back center of the pulp collector base.
This mechanism is an added safety
feature. Once the pulp collector
is in place the Activating Pin on
the bottom of the pulp collector
activates the Micro Safetyswitch.
This will protect you from accidentally
putting hands or fingers under the
machine while the blade is spinning.
Once the pulp collector is removed from
the main base the motor will not run.
Activating Pin
(Bottom of
pulp collector)