BODY STRAIGHTENER 10 TON CAPACITY MODEL 851/857 USER'S MANUAL
GENERAL SAFETY WARNINGS AND PRECAUTIONS 1. KEEP WORK AREA CLEAN AND DRY. Cluttered, damp or wet work areas invite injuries. 2. KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle this product. Do not allow children in the work area. 3. STORE IDLE EQUIPMENT. When not in use , tools and equipment should be stored in a dry location to inhibit rust. Always lock up tools and equipment and keep out of reach of children. 4. DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
HOW TO SET UP THE FRAME STARIGHTENER Frames and bodies are bent and distorted by collision with a relatively large area of the car bearing the impact. However, the correction procedure utilizes, powerful, concentrated loads at key points which can cause local crushing of frame members, etc., if these points are not property padded to spread the load over a large area. Illustration of recommended anchoring procedures are shown below for efficient use of the under body anchoring System.
24"Min 24"Min HOOK-UP SWAY AND MASH Unibody Construction HOOK-FOR SWAY WITH MASH Perimeter Frame(ladder frame) this configuration will move the frame forward and sideways at the same time. Thereby correcting combination damage in a single hookup. For vehicles with unibody construction, secure the body by using underbody clamps and rocker pinch welds.
HOOK-UP FOR SAG OR KICK-UP HOOK-UP FOR MASH With the car firmly supported on safety stands, place the body straightener under the frame rail to be corrected. Withe the use of underbody clamps, anchor both front and rear end of the vehicle with chain onto the beam of the body striaghtner. Place a bottle jack or portapower on the Dozer beam under the low area to raise it. This is a basic a pulling and stretching operation.
BODY STRAIGHTENER MODEL 851 21 20 27 22 22 20 06 16 15 16 15 19 04 19 11 14 08 13 25 12 17 18 09 1 2 05 25 10 26 07 26 24 24 04 23 16 03 23 04 PARTS LIST PARTS NO 01 02 03 04 05 06 07 08 09 10 11 12 13 14 DESCRIPTION QTY MAIN BEAM TILTING SUPPORT SPINDLE SNAP-RING"C" PIN POST BOLT 3*4"X7" SPRING WASHER NUT 3/4" LOCK PIN COTTER PIN SUPPORT SPINDLE 10 TON RAM 1 1 1 3 1 1 1 1 1 1 3 1 1 1 PARTS NO 15 16 17 18 19 20 21 22 23 24 25 26 27 5.
BODY STRAIGHTENER W/2TON CRANE MODEL 857 39 40 35 38 36 32 22 50 37 45 23 49 50 55 33 45 20 28 16B 34 15 23 24 02B 53 22 23 31 14 07 22 27 06 54 12 54 53 52 52 30 13 51 61 34 26 04 05 03B 56 08 05 19 59 18 17 18 09 NO 02B 03A 03B 04 05 06 07 08 09 10 11 12 13 14 15 16B 17 18 19 20 21 22 23 24 25 26 04 05 57 04 05 08 10 11 04 03A 04 05 PARTS 58 60 07 05 24 30 21 25 29 51 20 18 27 04 DESCRIPTION QTY MAIN BEAM FRAME CANNULA FRAME CANNULA SPRING