MODEL 65300 3 TON LOW PROFILE ALUMINUM FLOOR JACK USER'S MANUAL *This hydraulic jack conforms to all "ANSI / ASME" safety standards. Jackco Transnational Inc. © 2010 South El Monte, CA 888-452-2526 To see more jackco products please visit our website at www.jackco.
FOR YOUR SAFETY • Read these safety instructions carefully and keep this manual in an easy to find place as you may need to use it again. • Non-compliance with these rules may result in injury or damage to the jack or the vehicle. • Do not modify the jack in any way. • Never exceed the rated capacity of the jack. • This jack is a lifting device only and should never be used to move the vehicle. • The jack should be supported on a solid and level ground.
SPECIFICATION Capacity: Min Height : Max Height : Length: 3 tons 3.75 in 18.1 in 26.4 in Chassis Width: Saddle Diameter : Net Weight : 13 in 4.52 in 58 lbs PRIOR TO OPERATION Air may become trapped in the hydraulic system during transit. To Purge Air 1.Insert the handle into the socket and secure it with the set screw provided. 2.Turn the handle counterclockwise until release valve is open, pump the jack several times to purge the accumulated air in the system. 3.
MAINTENANCE Important: Both the maintenance and repair of the jack may only be performed by qualified persons, who have sufficient knowledge of the hydraulic system used in these jacks Regularly lubricate the moving parts in the wheels, arms, handle and pump roller pin. • Only original replacement parts should be used. Extremely Important: never use brake fluid. • When the jack is not in use, make sure the lifting arm is fully retracted to avoid corrosion.
TROUBLESHOOTING Caution: To prevent personal injury, all inspection, maintenance, and repair procedures must be performed when the jack is free of load. Trouble Cause 1.Release valve is open 2.Low/no hydraulic fluid in reservoir Jack does not lift 6.Seals worn or defective Jack advance slowly Jack lifts load, but doesn’t hold Jack leaks hydraulic fluid Jack will not retract 1. Verify the release valve is closed. Release valve may need cleaning. 2.
PARTS LIST
Part No. 1 2 3 4 5 6 7 8 9 Description Saddle Pad Saddle Screw Saddle Saddle Base Lift Arm Assembly Radius Rod Front Wheel Carrying Handle Side Plate Q'ty Part No.
LIMITED ONE YEAR WARRANTY Jackco Transnational Inc. warrants all Jackco equipment and tools to the original purchaser against any manufacturing defect in material or workmanship for a period of one (1) year from the original date of purchase.