MODEL 66500A /66510A 5 TON / 10 TON AIR/HYDRAULIC FLOOR JACK USER'S MANUAL *This hydraulic jack conforms to all "ANSI / ASME" safety standards. Jackco Transnational Inc. © 2012 South El Monte, CA 888-452-2526 To see more jackco products please visit our website at www.jackco.
FOR YOUR SAFETY • Read these safety instructions carefully and keep this manual in an easy to find place as you may need to use it again. • Non-compliance with these rules may result in injury or damage to the jack or the vehicle. • Do not modify the jack in any way. • Never exceed the rated capacity of the jack. • This jack is a lifting device only and should never be used to move the vehicle. • The jack should be supported on a solid and level ground.
SPECIFICATION Capacity: Max Height : Min Height : 5 Ton 560 mm/ 22 inch 150 mm / 5.9 inch Lifting Height : Gross Weight Net Weight : Capacity: Max Height : Min Height : 10 Ton 560 mm / 22 inch 160 mm / 6.2 inch Lifting Height : Gross Weight Net Weight : 410 mm / 16.1 inch 106 kg/ 233 lbs 92 kg / 202 lbs 400 mm / 15.7 inch 156 kg / 343 lbs 139 kg / 306 lbs SETUP Assemble the handle 1. Loosen the bolt on the handle socket. 2. Insert the handle. 3. Tighten the bolt.
Preventive Maintenance Important: Dirt is the greatest single cause of failure in hydraulic units. Keep the service jack clean and well lubricated to prevent foreign matter from entering the system. If the jack has been exposed to rain, snow, sand or grit, it must be cleaned before it is used. • Store the jack in a well-protected area where it will not be exposed to corrosive vapors, abrasive dust, or any other harmful elements.
TROUBLESHOOTING Caution: To prevent personal injury, all inspection, maintenance, and repair procedures must be performed when the jack is free of load. Trouble Jack does not lift Cause 1. Release valve is open 2. Low/ no oil in reservoir 3. Air-locked system 4. Load is above capacity of jack. 5. Delivery vale and/or bypass valve not working correctly. 6. Packing worn out of defective. 7. Leak in air line 8. Inadequate air pressure. Solution 1. Close release valve. 2. Fill with oil and bleed system. 3.
PARTS LIST
Description Frame Front wheel Washer Snap ring Grease fitting Rod link Bolt Saddle Lock washer Nut Spring Bolt Bolt Snap ring Shaft Rear wheel Nut Snap ring Shaft Washer Pin Connection bar Spring Snap ring Shaft Cover board Snap ring Washer O-ring Piston rod Piston ring Sealing washer O-ring O-ring retainer Snap ring Oil cylinder ass’y Oil filler plug Part No.
LIMITED ONE YEAR WARRANTY Jackco Transnational Inc. warrants all Jackco equipment and tools to the original purchaser against any manufacturing defect in material or workmanship for a period of one (1) year from the original date of purchase.
