MODEL 66200B 2 TON SUPER LOW PROFILE FLOOR JACK USER'S MANUAL *This hydraulic jack conforms to all "ANSI / ASME" safety standards. Jackco Transnational Inc. © 2014 Azusa. CA 888-452-2526 To see more jackco products please visit our website at www.jackco.
FOR YOUR SAFETY • The vehicle to be lifted should never exceed the rated capacity of the jack. • The jack should be supported on a solid and level surface, which is well illuminated and free of obstructions. Never use the jack in a surface at which it may sink into the ground. • Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine and apply the brake. Ensure the vehicle to be lifted against any type of sliding.
OPERATING INSTRUCTION 1. Prior to operating the jack, remove any accumulated air from the system as follows (1) Insert the handle into the socket and secure it with the screw provided (2) Pull the handle and turn it clockwise and whilst held in this position, pump the jack several times to ensure internal lubrication and bleed the accumulated air from the system. 2 Release the handle and it will automatically return back to the initial position. The jack is now ready to be used.
MAINTENANCE Important: Both the maintenance and repair of the jack may only be performed by qualified persons, who have sufficient knowledge of the hydraulic system used in these jacks Regularly lubricate the moving parts in the wheels, arms, handle and pump roller pin. 1. Only original spare parts should be used. 2. Prior to each user, check for bent, broken, cracked or loose parts and solve the problem, if appropriate.
PREVENTIVE MAINTENANCE Important: The greatest single cause of failure in hydraulic units is dirt. Keep the service jack clean and well lubricated to prevent foreign objects from entering the system. If the jack has been exposed to rain, snow, sand or grit, it must be cleaned before use. 1. Store the jack in a well-protected area where it will not be exposed to corrosive vapors, abrasive dust, or any other harmful elements. 2.
TROUBLESHOOTING Caution: To prevent personal injury, all inspection, maintenance, and repair procedures must be performed when the jack is free of load. Trouble Jack does not lift Cause 1. Release valve is open Solution 1.Verify the release valve is closed by position of handle. Releasing valve may need cleaning. 2.Fill with approved hydraulic fluid and bleed system 3.Bleed system 4.Use correct equipment 2.Low/no hydraulic fluid in reservoir 3. Air-locked system 4.Load is above capacity of jack. 5.
PARTS LIST Part No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Description Retaining Ring (20) Washer(20) Front Wheel Frame Retaining Ring(25) Nut(M16) Washer(16) Screw(M5X12) Rear Caster Screw(M10X25) Washer(10) Retaining Ring(15) Nut Shaft Washer(20) Nut(M8X20) Washer(8) Set Screw Handle Handle Socket Retaining Ring(12) Roller Q'ty Part No.
LIMITED ONE YEAR WARRANTY Jackco Transnational Inc. warrants all Jackco equipment and tools to the original purchaser against any manufacturing defect in material or workmanship for a period of one (1) year from the original date of purchase.
