Instruction Manual
1. Only original spare parts should be used.
2. Prior to each user, check for bent, broken, cracked or loose parts and solve the
problem, if appropriate. If the jack has been subjected to abnormal loads or has
suffered any drops, remove it from service until the problem has been rectied.
3. If the oil level needs to be checked or relled, with the piston fully retracted, remove
the ller plug and drain its contents into a container. The parts table shows the
volume of oil required. Make sure that no dirt enters with the new oil.
Following a period of prolonged intensive use, it is recommendable to change the oil
in order to extend the useful life of jack.
Important: an excess of oil may render the jack inoperative.
4. Only use hydraulic oil, type HL or HM with an ISO grade of viscosity of 30 cST at 40
degree, or an Engler viscosity of 3 at 50 degrees.
Extremely important: never use brake uid.
5. When the jack is not in use, make sure the lifting arm is fully retracted to avoid
corrosion.
6. Keep the jack in a clean, dry place and out of children’s reach.
7. At the end of the useful life of the jack, drain off the oil and hand it over to an
authorized agent and dispose of the jack in accordance with local regulations.
8. Both the repair kit, which exclusively contains the o-rings and seals of the jack, and
the spare parts sets must be ordered using the part number assigned in the table.
MAINTENANCE
Important:
Both the maintenance and repair of the jack may only be performed by
qualied persons, who have sufcient knowledge of the hydraulic system used in these
jacks
Regularly lubricate the moving parts in the wheels, arms, handle
and pump roller pin.
4