LIMITED ONE YEAR WARRANTY Jackco Transnational Inc. warrants all Jackco equipment and tools to the original purchaser against any manufacturing defect in material or workmanship for a period of one (1) year from the original date of purchase.
WARNING • All WARNING statements must be carefully observed to help prevent personal injury. • Do not exceed rated capacity. • All devise used must be rated for the same maximum operating pressure, correctly connected and compatible with the hydraulic fluid used. An improperly matched system can cause the system to fail and possibly cause serious injury. • Use only on hard, level surfaces capable of sustaining rated capacity loads.
PRODUCT DESCRIPTION Power Post is designed for the rated capacity lifting and pulling jobs. This power post can shall used with common pot patterns. Operator can create their own custom pull system. A wide variety of applications exist for this category of product. Special skill, knowledge and training may be required for a specific task and the product may not be suitable for all the jobs described above.
SET UP Suggestion: install a pressure gauge (not included) on your pump to indicate a relative level of pulling force. 1. Secure the threaded ram to bottom of power post, then connect ram to air pump with hydraulic hose provided. 2. Slide the pull chain thru the chain pulley, idle pulley and power lever arm. 3. Secure the safety chain on chain pulley to an anchor pot. Note: The dual chain helps to divide the pull force exerted by the post and also allows positioning the post between two anchor pots.
MAINTENANCE 1. Inspect and replace damaged, kinked, twisted, stretched or rusty chain. 2. Inspect hoses and connections. Replace damage components immediately with Jackco replacement parts only. 3. Tighten connections as needed. Use non-hardening pipe thread compound when servicing connections. 4. Use only good quality hydraulic fluid. We recommend Jackco Model 01010 Hydraulic Oil or equivalent.
PARTS LIST Please refer to the Parts drawing when ordering parts. Not all components are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence. When ordering parts, please give model no., and description below. Call or write for current pricing: Jackco Transnational Inc. South El Monte, CA 91733 TEL: (626)582-8055 or visit us at www.jackco.
