Instructions / Assembly

Installation:
1. The 24 in. Septic Tank Riser Cover will fit most 24 in. installed risers. Test fit the 24 in. Septic
Tank Riser Cover to make sure it is correct for your riser.
2. Clean the sealing surface of your riser.
3. Remove the hardware pack containing the four square-drive screws from the back of the 24
in. Septic Tank Riser Cover.
4. Place the 24 in. Septic Tank Riser Cover on your riser. Make sure the rubber seal is making
a seal with the top of your riser.
5. Using the four screw holes in the cover as a guide, drill four 3/16 in. holes through your riser.
6. Some risers may require the use of holes other than the molded screw holes into the 24 in.
Septic Tank Riser Cover. For these risers, use the two additional drill points molded on the
top of the cover.
7. Install the provided screws with a #3 square driver.
8. For access to your riser just remove the screws and cover, then reinstall as above.
Safety Information:
Warranty:
www.jackelinc.com
574-256-5635
!
WARNING: Do not enter septic tank without proper equipment. Dangerous
gases exist inside tank.
Package Contents Tools Required
Safety Goggles
3/16 in. Drill
For more information please visit our website: www.jackelinc.com/warranty
Installation Guide
24 in. Septic Tank Riser Cover
Model: SFRC24G
Cover
4 x Screws
#3 Square Driver