Product Manual

Assembly Instructions
Operating Instructions
JackJaw
®
500 Series Assembly and Operating Instructions
Step 1: Place contents of
box on oor or table. Place
handle over riser tube with
decal facing up and insert
short 1/2” - 22 bolt.
Step 2: Start 1/2”-22
self locking nut on to
bolt. Tighten bolt using
two 3/4” wrenches.
Step 3: Swing link arms up to
handle. Insert the long 3/8”-
24 bolt through link arms and
handle. Install at washer on
bolt. Start 3/8”-24 locking nut
on bolt.
Step 4: Use two 9/16” wrenches
to tighten riser bolts and nuts and
link arms onto handle.
Note: After nut is tight against
washer, then, back off the nut on
the link arm bolt one half turn
from the washer. Handle should
raise and lower freely.
Construction Accessories, Inc. • Phone [phone] • Fax [phone]
email: [e-mail] • www.jackjaw.com
Printed in U.S.A. • Product Made in the U.S.A.
Step 1: Lift handle to up position so that jaws are fully open.
Step 2: Place unit so that jaws are on either side of the lip of
the U picket. Figure 1 and 2 below.
Step 3: Place foot on or close to base. Figure 3 below. Push
down on handle, clamping on stake or lip of U picket and lifting
it out of the ground.
Step 4: Repeat motion as necessary until post is free.
Caution: Never put your ngers or hands between the jaws, or
between the jaws and the post.
Replacement Jaw Set - 4 jaws & hardware Part # CA0003
1.
2.
March 2011
Stake/Post Removal from Tilted Ground
Step 1: The central post of the stake puller should be aligned
with the sign post/stake that is being removed. If the ground is
uneven, use two blocks of wood to level the base of the stake
puller so that the central shaft is parallel to the sign post/stake
Step 2-4: Same as Basic Stake/Sign pulling.
Basic Stake or Sign Pulling
Tip: In soft conditions or mud, place a
short piece (1 to 2 feet in length) of 2
x 6 lumber under the base of the unit.
This will spread the force over a larger
area, allowing stake removal even in
muddy conditions.
3.
Completed
Assembly
Handle Extension: Remove clevis pin in handle, extend inner
handle to desired length and replace clevis pin. See below.
JJ0500 handle in normal position
JJ0500 handle in extended position