Product Manual

Construction Accessories, Inc. • 3880 Haines Rd. • Waynesville, OH 45068-9610 • Phone: [phone] • fax: [phone]
E-mail: [e-mail] • www.jackjaw.com
Stake
Extractors
That Work!
Assembly Instructions JJ0313/513 August 5, 2015
JackJaw
®
Stake Tester Assembly Instructions
Tools Required: Two ¾” wrenches. Two 9/16” wrenches
Your finished assembly should look like photo on right
1. Open the boxes and move the contents to a work bench or the floor with
the central post standing on base.
2. Rotate the Mount/Slide Block Assembly around the post so that the
jaws are facing outward, away from the base.
3. Place the lever arm over top of the post, and insert the ½” (large fat)
bolt through the side of the lever arm and through the pivot pushing of
the post.
4. Start the ½” nut onto threads of pivot bolt with fingers. Use two ¾” wrenches to tighten the
nut onto the bolt until snug. Lever arm should pivot up and down freely.
5. Put lever arm over your shoulder (or have someone lift the lever arm) while lifting the load cell
mount up to the front of the lever arm. Rotate the tabs up to the front bushing of the lever
arm, placing one tab on each side of the lever arm. Insert long 3/8” bolt through the tab,
lever arm front bushing and opposite tab. See photo below.
Tab
Tab
Long 3/8” Bolt & Nut