Product Manual

6. Place the washer on the threaded side of the bolt. Start the 3/8” nut with fingers onto the bolt.
Using two 9/16” wrenches, tighten the nut to the bolt until snug up against the washer. Then,
back off the nut a ½” turn. The lever arm and load cell mount should move freely when lifting
the lever arm.
7. Remove the Transport Link and store the link in the case for the EDJr-1T load cell.
8. Remove the EDJr-1T load cell from its case. Insert the batteries as shown in the enclosed
quick start brochure.
9. Place the top ring of the load cell in the upper left
side of load cell mount. Insert the½” clevis pin
through mount and load cell as shown below.
Immediately insert the clip pin to lock the clevis
pin in mount.
10. Swing the lower link arm to the bottom of the load cell. Insert the second (skinny one) clevis
pin through the link arm and lower Load cell hole. Insert clip to lock lower clevis pin in link
arm.
You are now ready to test the holding power of stakes. See the operating instructions on using the
Assembly Instructions JJ0313/513 Page 2
Construction Accessories, Inc. • 3880 Haines Rd. • Waynesville, OH 45068-9610 • Phone: [phone] • fax: [phone]
E-mail: [e-mail] • www.jackjaw.com
Clevis Pin
Assembled unit back view.
Clip pin