R24/R30 Glasswasher Maintenance Instructions Heater Replacement 07610-003-12-39 A September 23, 2005
www.jacksonmsc.com Jackson glasswasher machines come equipped with heaters to ensure proper ware washing results. Occasionally, some of these components may need replacing to maintain optimum performance. Jackson offers all of the repair parts necessary for performing this task. The instructions provided here are for maintenance personnel only. Unauthorized persons should not attempt any of the steps contained in these instructions. STEPS 1. Remove the front door. 2.
www.jacksonmsc.com Removing upper (wash) strainer. 5. Using the 3/8” nutdriver, remove the nuts securing the heater wires to the heater. Then carefully pull the wires out of the way. Reaching into the wash tank. 7. Removing the heater may require that you reach into the wash tank, grasp it and try give it a push out of the wash tank. 8. Once the heater is pushed away from the tank wall, pull it out with your hands. Removing the heater nuts. Pulling the heater out.
www.jacksonmsc.com 9. Remove the old heater gasket and throw away. AFTER MAINTENANCE ACTIONS 10. Apply the new heater gasket. 11. Take the new heater and slide it through the hole in the wash tank and line it up so the wash tank studs fit in the holes on the heater flange. Service personnel may want to drain the machine and allow it to cool down. Secure power to the unit at the service breaker and then verify the torque of all fasteners covered in this instruction. 12.
