Dishmachine Maintenance Instructions Rinse Regulating Thermostat Replacement (From EGO brand to Stemco) 07610-003-13-91 A November 16, 2005
www.jacksonmsc.com Many dishmachines comes with integral booster tanks to ensure proper temperature of the final rinse. Jackson has predominantly used two manufacturers of thermostats, EGO and Stemco. These instructions are for use with kit 06401-003-13-94, which is to replace an EGO rinse regulating thermostat with a Stemco brand. Jackson offers all of the repair parts necessary for performing this task. The instructions provided here are for maintenance personnel only.
www.jacksonmsc.com Removing the imperial brass fitting. Attaching the jumper wires. Pulling the thermostat probe and fitting from the well. Sliding imperial fitting onto new thermostat. 6. Slide the new imperial brass fitting from your kit onto the new thermostat. Removing the wires from the thermostat. 5. Attach the jumper wires to the wires that you removed from the old thermostat. Putting the new thermostat in the well. 7.
www.jacksonmsc.com 10. Use the phillipshead screwdriver to remove the attachment screws on the thermostat for the NORMALLY CLOSED and COMMON points. Tightening the brass fitting. 8. Use the 7/16” combination wrench to tighten down the brass fitting, while also positioning the new thermostat so that it does not hang over the heater. Fitting the jumper into the mounting cup. 11. Attach the ring ends of the jumpers to the cups/screws removed from the thermostat and attach them.
www.jacksonmsc.com on the machine data plate for every cycle. Calibrating the new thermostat. SPECIAL NOTES Work performed on Jackson dishmachines by unauthorized or unqualified personnel may void the warranty. Before beginning this or any other maintenance evolution on a unit under warranty, you should contact a certified Jackson technician or Jackson Technical Service. You can find a list of qualified service agencies in the back of you unit’s installation manual.
