Installation Sheet

j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133
CREATED 1.30.2018
JACLO.COM
|
PG 3
INSTALLATION
1. Place template (1) in desired location. Knock out the center circles in upper and lower bracket
drawing.
2. Using level, mark the two center holes on tile/wall.
3. Drill 1/4” holes in desired locations for mounting brackets (6) and insert plastic anchors (7).
4. Remove back posts (5) from wall bar and while keeping mounting bracket (6) in place, screw
into anchors (hand tighten, NO POWER DRILLS/DRIVERS)
5. Place wall bar (2), slider (3) & posts (4) into position (holder should be on left side of bar) and
screw back post (5) onto post (4) by turning clockwise onto bar.
**NOTE: Wall bar will sit about 1/16” from wall for mounting and demounting. DO NOT CHAULK
BEHIND BACK POST AS THAT WILL PREVENT IT FROM TURNING.**