User Manual

IMPORTANT:

Please leave these instructions with the installed grab bar.

They contain valuable product warranty information for future reference.

See page three for finish maintenance.

jaclo i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016

p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133

JACLO.COM

GRAB BARS

PG 1 REVISED JULY '08

Installation Instructions

Luxury Grab Bars

Product Number G20, G21, G30, G33, G60, G61 and G70 Series

PAGE 1
Installation Instructions Luxury Grab Bars Product Number G20, G21, G30, G33, G60, G61 and G70 Series IMPORTANT: Please leave these instructions with the installed grab bar. They contain valuable product warranty information for future reference. See page three for finish maintenance. JACLO.COM GRAB BARS | PG REVISED JULY '08 j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016 p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.
PAGE 2
Important Information: 1 › Our 1-1/4" grab bars have been designed and tested to meet or exceed the standards required for CABO/ANSI 117.1. They have been designed to be attached to a wall using the encloded #14 x 3" long stainless steel screws into a wood stud or 1" plywood adequately supported by metal or wood studs. It is the responsibility of the installer (builder or architect) to insure that the correct hardware is used and that the wall construction is adequate.
PAGE 3
Installation Instructions for Angular Grab Bars: 1 › Mark center of holes for mounting screws. 2 › Drill 1/8" diameter holes. 3 › Place escutcheon on post hubs and place on wall. Drive #14 x 3" screw into 1" plywood or wood stud, DO NOT TIGHTEN. Note: Soap applied to screw threads will reduce the power required. 4 › Repeat for other side. 5 › Make sure grab bar is aligned properly, then tighten all srews. 6 › Install press caps. 7 › Install handshower if supplied.