Operation Manual

37
D.10. Talk display
You can select the type of information displayed during a call – the time or the call
or the caller’s number (if available). The default setting is “Time”.
Key Map:
Display Talk Display select Time/Number
1. Press to access the main menu.
2. Press
/ to select “Display”. Press
3. Press
/ to select “Talk Display”. Press
4. Press / to select “Time” or “Number”. Press
5. Press to exit and return to standby mode.
D.11. Tones
Key Map:
Audio Setting Tones select your option
select On/Off
You can switch on or off the tones for key touch, confirmation, call waiting, and
out-of-range alarm. For example, when the key tone is set to “On”, you will hear a
tone each time you press a keypad button.
1. Press
to access the main menu.
2. Press
/ to select “Audio Setting”. Press
3. Press / to select “Tones”. Press
4. Press / to select the option (i.e. “Warning”, “Call waiting”, “Range
Alarm”) and to confirm.
5. Press
/ to display either “On” or “Off” and press to confirm.
For “Key”, select from “Pattern 1-3” or “Off” and press
6. Press to exit and return to standby mode.
D.12. DIAL mode
You can set your phone to use either “Tone” or “Pulse” dialing. The pre-set setting
is “Tone” dialing, where you will hear a tone beep each time you dial a number.
Most modern exchanges and switchboards use “Tone” dialing, so you should not
need to change this setting. Only change it if your service provider or switchboard
uses “Pulse” dialing.
Key Map:
Setting Base Additional Dial Mode
select Tone/Pulse
1. Press to access the main menu.
2. Press
/ to select “Setting Base”. Press
3. Press / to select “Additional”. Press
4. Press / to select “Dial Mode”.Press . The current setting is
displayed.
5. Press
/ to select either “Tone” or “Pulse”. Press to confirm.
6. Press
to exit and return to standby mode.
D.13. Tone dialing Switch-Over
If you have set your phone to use “Pulse” dialing, you can switch temporarily to
“Tone” dialing for the duration of a call:
1. Press
2. Enter the number you want. Press and hold “D” will be displayed. Any
digits entered after the “D” will be dialed using tone dialing.