User Guide

The optional skirt is designed to allow the minimum service access necessary to the motor/pump and plumbing of the

bath and consists of three pieces; left-hand fixed, right-hand fixed, and removable front panel, along with the necessary

bottom rail and hardware for installation. (See the Illustration above.)

Allow clearance of at least 8" in front of the bath for skirt removal. The skirt should be attached after the bath has been

installed.

As part of the roughing-in of the bath, follow these steps to ensure that the bath skirt fits properly.

5' Corner Style Bath Skirt

Installation Instructions

Install the bath unit per instructions supplied with

the product.

RIGHT-HAND

FIXED SKIRT

LEFT-HAND

FIXED SKIRT

BOTTOM RAIL

REMOVABLE

SKIRT

Check that wall structure is plumb and square

to the floor.

90°

PAGE 1
5' Corner Style Bath Skirt Installation Instructions RIGHT-HAND FIXED SKIRT LEFT-HAND FIXED SKIRT BOTTOM RAIL REMOVABLE SKIRT The optional skirt is designed to allow the minimum service access necessary to the motor/pump and plumbing of the bath and consists of three pieces; left-hand fixed, right-hand fixed, and removable front panel, along with the necessary bottom rail and hardware for installation. (See the Illustration above.) Allow clearance of at least 8" in front of the bath for skirt removal.
PAGE 2
Bath Skirt Installation The bath should already be set and leveled. Electricity should be connected and bath unit tested to be sure it is working properly before installing the skirt. PLUMB LINE OR SQUARE FROM EDGE OF BATH RIM Mount the five shell clips to the wooden blocks located under the rim of the bath. (See Illustration 1.) Shell clips are to be located 5/8" from the inside of the bath rim edge. Mark hole locations on the blocks using one of the clips as a template.
PAGE 3
REMOVABLE SKIRT WOODEN BLOCK LIFT TOP OF SKIRT UP UNDERNEATH RIM OF BATH SHELL CLIP VELCRO® LOOP TAPE HOOK TAPE 2" 3" INTERLOCKING VELCRO® TAPES BOTTOM RAIL 5. CENTER LINE Clean an area about 2" long in the center, and 3" from each end of the rail and the bottom of the skirt with isopropyl alcohol. (See illustration 5). Attach strips of Velcro®, as before, hook tape to rail, loop tape to skirt, ensuring that they will mesh when the skirt is installed. 6.