ams7236 wlr 2ch installation sheet

Installation
English
www.jacuzzi.com Page 7
Assemble in accordance with the local plumbing or
building codes.
1. Identify drain overow kit provided with your bathtub.
Remove and open the overow package and conrm
that all parts are present.
2. Remove washers and nuts from the overow tting.
3. Place a small bead of plumbers putty, silicone, or
similar approved sealant around the underside of the
top ange of the overow tting.
4. Place the overow tting into the overow hole of the
bathtub (Figure 4).
5. From the underside of the unit, place the rubber washer
then locknut on the overow tting and tighten securely.
Be careful not to overtighten.
6. Assemble the remaining drain pieces as shown in the
illustration.
7. After the drain is fully installed, test for proper drainage.
If the unit does not drain properly, rectify this condition
before proceeding with further bathtub installation.
Watertight installation of the drain and overow
is the installer’s responsibility. Drain leakage is
excluded from the Jacuzzi Luxury Bath warranty of
this product.
OPTIONAL - If the Fuzion
®
Wood Frame is not
being used, please proceed to Step 2 in the
Undermount Installation section on page 11.
Fig. 4
Overow Fitting
Apply sealant/caulking
(commercially available)
Flat Rubber
Washer
Lock Nut
Direct Waste Overow Drain
Fuzion
®
Specic Material
Fuzion
®
Overow Drain Installation
Figure 4 - Overow Installation
The additional design features of the Fuzion
®
require that the following steps be completed prior to installing the bathtub
in the constructed surround. The following steps must also be completed in the order specied:
1. Fuzion
®
Faucet Installation
2. Fuzion
®
Overow/Drain Installation
3. Fuzion
®
Wood Frame Installation
4. Fuzion
®
Control Panel Installation
Fuzion
®
Faucet Installation
Selecting a faucet for rim mounting: The combined thickness at the rim of the bathtub shell and optional
wood deck is 2˝ (50mm) nominal. The length of the faucet tailpiece(s) must be long enough to extend past
this dimension and have ample clearance to assemble any hardware (i.e. locknut, water supply fittings, etc.)
necessary for installation. For undermount units, the combined thickness of the bathtub shell is ½˝ (12mm)
nominal and the undermount deck should not exceed the length of the faucet tailpiece(s), including any
assembly hardware.
Overow Drain
Assembly
Direct Waste
Overow Drain
Waste Elbow
Twist and Turn
Drain Assembly
PVC Pipe
PVC Pipe
PVC Flex Pipe
PVC Flex Pipe
PVC Flex Pipe
PVC 45 Elbow
PVC 45
Elbow Street
PVC 45 Elbow Street
PVC 45 Elbow