Installation Sheet
Installation
English
Page 8 www.jacuzzi.com
Fuzion
®
Frame Installation
If you are installing a Fuzion
®
bathtub with accessory
frame, please refer to the Fuzion
®
Frame Installation
Guide (#GL44000) before proceeding any further.
Complete the installation and assembly steps according
to the Fuzion
®
Frame Installation Guide.
Fuzion
®
Control Panel Installation
Fuzion
®
Frame
Control Box Wire
(Black Wire)
Control Panel
Adhesive Application
Control Panel
Control Box Wire
(Adhesive)
Inside of Bathtub
The following cutouts must be clear and free of any dirt
or adhesive:
- Control panel cutout in the assembled wood frame
- Control panel cutout in the assembled counter
- Control panel cutout in the bathtub
1. Insert the wire connector into the back of the control panel
(Figure 5).
2. Sparingly apply adhesive around the base of the control
panel (Figure 6).
3. Thread the wire through the cutout and to the control box.
4. Orient control panel in the following manner: the logo will
be on the right side of the J4 control panel when you are
sitting in the bathtub (the power button will be on the right
side of the J5 LCD control panel).
5. Lower the control panel into the cutout and press rmly to
embed the adhesive (Figure 7).
6. Connect the wire to the control box.
7. Please proceed to Step 3 in the Drop-In Installation
section on page 10.
Fig. 5
Fig. 6
Fig. 7
Fuzion
®
Specic Material (Continued)