Plumbing Product User Manual

ManualsBrandsJacuzzi ManualsPlumbing ProductBM43000

Installer: Leave this manual for homeowner.

Homeowner: Read this manual and keep for future reference.

UNDERMOUNT LAVATORY

INSTALLATION INSTRUCTIONS

Save These Instructions for Future Use.

Owner's Record

Date Purchased _________________________________________

Purchased From _________________________________________

Installed By _____________________________________________

Serial Number ___________________________________________

Model __________________________________________________

Summary of content (8 pages)

PAGE 1
UNDERMOUNT LAVATORY INSTALLATION INSTRUCTIONS Installer: Leave this manual for homeowner. Homeowner: Read this manual and keep for future reference. Save These Instructions for Future Use.
PAGE 2
BEFORE YOU BEGIN READ AND FOLLOW ALL INSTRUCTIONS ! Observe all local plumbing and building codes. ! Carefully inspect the new lavatory for damage. ! If the existing lavatory does not have supply shut-off valves, you will install them before installing the new lavatory. ! Rough-in information is included with your lavatory. The rough-in information shown will be helpful in placing the lavatory, water supply piping, shut-off valves and drain in their proper positions.
PAGE 3
REMOVING YOUR OLD LAVATORY For new construction begin with INSTALLING YOUR NEW LAVATORY 1. Turn off the water supply. This is done by closing the two shut-off valves located under the lavatory. If there are no shut-off valves leading to the lavatory, you must turn off the water at the main valve. This is usually located in the basement, garage, or near the foundation on the outside of the house. It may also be near the water meter.
PAGE 4
INSTALLING YOUR NEW LAVATORY There are many ways to install an undermount sink, and the details of the installation will depend on the quality of your cabinets and countertop. This installation guide describes only one way of installing an undermount sink. These instructions assume that you are working with a base cabinet with no sink or countertop currently installed. The countertop you are going to install will also need to have holes cut to accommodate the sink and faucet. 1.
PAGE 5
8. Installer must determine the best way to drill holes in the countertop, ensuring proper alignment with the sink without damaging the finished countertop surface. 9. Install the faucet according to the faucet installation instructions, inserting the faucet through the faucet holes in the sink and the countertop. The faucet holes in the sink have been enlarged to allow the faucet to be raised through the countertop.
PAGE 6
CARE AND CLEANING For general cleaning, use a mild, nonabrasive soap and warm water. Do not use abrasive cleaners. Such cleaners contain sand or silica and will eventually scratch the surface. PARTS Parts Policy In order to avoid unnecessary delay or uncertainty in the satisfaction of warranty claims, buyers are advised to return alleged defective parts to the place of purchase. Sellers are authorized to address and resolve all warranty claims on fixtures directly with buyers.
PAGE 7
LIMITED WARRANTY JACUZZI WHIRLPOOL BATH (“Jacuzzi Whirlpool Bath”, “we”, “us”, “our”), warrants to the original consumer/purchaser for the applicable warranty period set forth below, that the products we sell are free from defects in material and workmanship, except as otherwise indicated below. PRODUCTS WARRANTY PERIOD (commences upon date originally installed for its intended purpose) • All cast iron sink products with porcelain enamel finish.
PAGE 8
LIMITED WARRANTY (cont'd) If you believe that a product fails to meet the above limited warranty, you should notify us in writing prior to expiration of the applicable warranty period set forth above at the following address: Jacuzzi Whirlpool Bath Warranty Service Department P.O. Box 702168 Dallas, TX 75370-2168 Notification should include a description of the product, model number and how the product fails to meet the above warranty.