TWO-PIECE FREESTANDING BATH SERIES INSTALLATION AND OPERATION INSTRUCTIONS Jacuzzi Luxury Bath 13925 City Center Drive, Suite 200 Chino Hills, CA 91709 www.jacuzzi.
Two-Piece Freestanding Bath Series English Contents Contents....................................................................................................................................................................... 2 Product Information...................................................................................................................................................... 2 Safety Instructions.........................................................................................
Two-Piece Freestanding Bath Series INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. This is a professional grade product. A knowledge of construction techniques, plumbing and electrical installation according to codes are required for proper installation and user satisfaction. We recommend that a licensed contractor perform the installation of all Jacuzzi Luxury Bath products. Our warranty does not cover improper installation related problems.
Two-Piece Freestanding Bath Series English Safety Instructions (Continued) WARNING: RISK OF HYPERTHERMIA AND POSSIBLE DROWNING! Do not use a hydromassage bathtub equipped with a heater immediately following strenuous exercise. WARNING: RISK OF ELECTRICAL SHOCK! • Do not permit electrical appliances (such as a hair dryer, lamp, telephone, radio or television) within 60˝ (1524 mm) of this hydromassage bathtub.
Two-Piece Freestanding Bath Series 1 Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only. 2 Inspect the shell and bathtub components.
Two-Piece Freestanding Bath Series English Two-Piece Freestanding Bath Series Installation Procedures Before you begin your installation, please read the following: • Observe all local land building codes. • Determine which tools will be used during the installation. • Additional bathtub drain ports and plumbing are commercially available at plumbing and hardware stores. • Drain/Overflow rough-in information is included in your bathtub in the Technical Specifications section.
Two-Piece Freestanding Bath Series Two-Piece Freestanding Bath Series Installation Procedures (Continued) Leveling (Bravo™ Models) Figure 3 1 2 Use a screwdriver and loosen the level adjustment bolts (Figure 1). Adjust bolts until level. Tighten the level adjustment bolts after leveling is achieved. English Level Once the unit is in position, ensure it is level in both directions for proper draining. Leveling must be done with the adjustable legs located beneath the unit.
Two-Piece Freestanding Bath Series English Installation Procedures (Continued) Remote Blower Installation For ease of installation of remote blower and airline fittings, it is recommended there be access to the underside of the bathtub, either from above or below the sub floor. 1 Determine the locations for the blower and verify that access to blower and airline fittings will be possible after bathtub is installed. Blower location must be within 10 feet of the tub as illustrated (Figure 7).
Two-Piece Freestanding Bath Series Operation (Continued) English Increase Speed Press the Up Arrow Button to increase blower speed. There are five blower intensities. Each push and release of the button will increase blower intensity through five incremental steps. Alternately, if the Up Arrow button is depressed and held, the blower intensity will increase through each of the 5 blower intensities, stopping when the button is released. Decrease Speed Press the Down Arrow button to decrease blower speed.
Two-Piece Freestanding Bath Series Troubleshooting Procedures English Problem Probable Cause Reset GFCI and/or breaker. Ensure plug is fully in outlet. Ensure control panel is connected to control box. Contact Jacuzzi Luxury Bath @ 800-288-4002. Blower does not start. No power to blower Blower not connected Blower is defective Blower operates but NO air is exiting the holes. Check to see if the plumbing is connected to the blower Blower operates but air is not exiting all of the holes.
Two-Piece Freestanding Bath Series If you need a referral for a service company near you, or need assistance with operation or maintenance-related questions, please call our Service Support Department at 1-800-288-4002. Visit our website at http://www.jacuzzi.com/ for products, services, and an online copy of these Installation and Operation Instructions. When requesting service or technical assistance please have available both the model and serial number of your unit.
Two-Piece Freestanding Bath Series English Notes: ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ___________________
Limited Lifetime Warranty on Jacuzzi® Branded Bathtubs Jacuzzi Luxury Bath (the “Company”) offers the following expressed limited lifetime warranty to the original purchaser of any Jacuzzi Luxury Bath products provided in the Company’s Comfort and Luxury collections (“Bath”) who purchases the Bath for personal or single family residential use (“User”): The Company will repair or replace, at its sole option, the Bath or its equipment in accordance with the following terms and conditions.
RETURN OF WARRANTY REGISTRATION OR NO WARRANTY To register your product, please go to our web-site Jacuzzi.com, click on Bath and Showers, then select ONLINE WARRANTY REGISTRATION from the top of the page. You will then be prompted to enter your product Serial Number followed by your warranty registration information. Or you may also register by completing the registration below and mailing it to jacuzzi at the address provided below.
14525 Monte Vista Avenue Chino, California 91710 Jacuzzi Luxury Bath
Español WARRANTY REGISTRATION CARD To complete your registration, visit our website at www.jacuzzi.com or fill out and mail this card to the address printed on the other side within thirty (30) days from date of purchase in order for this warranty to be come effective.
