Installation Sheet

 SignatureSeries
InstallationandOperation www.jacuzzi.com Page7
SignatureSeries
English
 SignatureSeries
Installation Procedures (Cont)
Fig. 4
Fig. 5
Fig. 6
Fig. 7
A. Drop In Installation
 1.Preparethecutoutholeforthebathtubusing
 theprovidedtemplate(Figure4).
 
NOTE
 Pleasefollowtheinstructionslistedonthe
 template(included)tocorrectlymarkthecutout
 hole.Thetemplatemayshowguidesformore
 thanonebathtub,becertaintoselectthe
 appropriateguidelines.Ifundermountingisan
 option,becarefultoselecttheguidelinesthat
 applytotheinstallationthatyouareperforming.
 2.Placeapieceofscraplumberoneachofthe
 endsofthecutout–thiswillbeusedasa
 temporarysupportpriortoloweringthebathtub
 fullyintotheopening(Figure5).
 3.Installtheunit,insertingthemotor/pumpend
 rst,loweringthebathtubintotheopeningas
 shownintheillustration.
 4.Thebathtubmustbesetlevel.Tocheck,use
 alevelontopoftheledgesonbothendsoftub
 andontopofthreshold(Figure6).
B. 3-Wall Alcove Installation
 1.Placethetubinthealcovewiththefrontskirt
 rmlyontheoor.Thebathtubmustbeset
 level.Tocheck,usealevelontopoftheledges
 onbothendsoftubandontopofdam
 (Figure7).
 2.Afterlevelingtub,markeachstud(concreteor
 blockwall)immediatelyabovetheback
 horizontalange.Removetubfromalcove.
 Measurethedistancebetweenthetopofthe
 backhorizontalangeandthebottomofthe
 tubledgeapproximately1½"(40mm).
 Carefullymarkthisdimensionontheback
 studs(orwall),belowtherstmark(Figure7
 inset).
 3.InstallaLedgerStrip:Jacuzzimandatesthe
 useofsupportsundertherearledgesof
 bathtubstopreventshifting.Usehorizontal
 ledgerstripalongtheentirerearledgeor“I”,
 “T”supportsinatleasttwoplacesinvertical
 position.Naila1"x3"x60"(25mmx75mmx
 1525mm)ledgerstripimmediatelybelowthe
 lowermarksmadeonframing(Figure7-
 inset).
Template
ScrapLumber
Level
Topof
LedgerStrip
Ledger
Board
Level
1.50"