Installation Guide

Jacuzzi
®
Comfort Pure Air™ II Bath: Installation and Operation Page 15 BM62000D • February 2008
ENGLISH
CLEAN-UP AFTER INSTALLATION
The acrylic nish will give long-lasting beauty when properly
maintained. To avoid dulling and scratching of the nish,
never use abrasive cleaners or harsh chemicals. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal
tools will scratch the surface. Spots left by plaster or grout can
be removed if lightly rubbed with a mild detergent and a damp
cloth or sponge.
Minor scratches that do not penetrate the color nish can
be removed by lightly sanding the surface with a 600-grit,
wet-dry sandpaper. To restore the glossy nish, use a special
compound like Meguiar’s No. 10 Mirror Glaze. If it is not
available, use an automotive rubbing compound followed by
an application of automotive paste wax.
Major scratches and gouges that penetrate the acrylic surface
may require renishing. Ask your Jacuzzi
®
Whirlpool Bath
dealer for special instructions or visit our web site at:
http://www.jacuzzi.com/
To nd service agent listings for:
Electrical or Mechanical Repairs, visit:
http://jacuzzi.com/pdf/ASA.PDF
Finish, Surface, or Shell-Related Repairs, visit:
http://jacuzzi.com/pdf/AFC.PDF
Repair Parts or Accessories, visit:
http://jacuzzi.com/pdf/MPD.PDF
DRAIN INFORMATION
A drain/overow assembly (sold separately) must be installed
on the bath, water tested, and connected to the sanitary
system of the house. After opening the carton, inspect for
damage and verify that the kit is in the proper nish. Follow
the installation instructions provided with the drain/overow
kit. After the drain is fully installed, test for proper drainage. If
the unit does not drain properly, rectify this condition before
proceeding with the installation. Jacuzzi
®
Whirlpool Bath is not
responsible for removal or reinstallation costs.
NOTE: Watertight installation of the drain is the installer’s
responsibility. Drain leakage is excluded from the warranty of
this product.
PLUMBING
All Comfort Plus Series air baths are factory tested for proper
operation and watertight connections prior to shipping. If
leaks are detected, notify your dealer immediately. Do not
install the unit.
WATER SUPPLY
Consult local authorities for plumbing code requirements in
your area.
IMPORTANT: Proper installation of the ll spout plumbing
and compliance with local codes are the responsibility of
the installer. Jacuzzi
®
Whirlpool Bath does not warrant
connections of water supply ttings and piping, ll systems, or
drain/overow systems. Nor is it responsible for damage to
the bath which occurs during installation.
CAUTION: A nonammable protective barrier must be placed
between soldering work and bath unit to prevent damage to
the bath.