Installation Guide

Important: Read complete instructions before beginning installation.

Each shower base is shipped with a drain and stainless steel strainer. An optional bright brass strainer is available

for installation on the drain assembly.

Remove the shower base from the carton. Do not destroy the shipping carton until after satisfactory

inspection of the product.

Immediately upon receipt, inspect the base before installing. Should inspection reveal any damage or defect in the

finish, do not install the base. Damage or defect to the finish claimed after the base is installed is excluded from the

warranty. Jacuzzi Whirlpool Bath’s responsibility for shipping damage ceases upon delivery of the products in good

order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations,

refer to the published warranty information packaged with the product. Jacuzzi Whirlpool Bath is not responsible for

any defect that could have been discovered, repaired, or avoided by following this inspection and testing procedure.

Plan the installation in relation to the finished wall surfaces. Take into account the dimensions of both the shower

base and the shower door enclosure to be used with it.

10-1/2" x 5"

DRAIN CUT-OUT

15-3/8"

33-1/4"

25"

60-1/4"

FRONT OF DOUBLE STUDS

SUB-FLOOR

FRAMING DETAILS

90º