ESPREE™ BATHTUB SERIES INSTALLATION AND OPERATION INSTRUCTIONS Jacuzzi® Luxury Bath 14525 Monte Vista Avenue Chino, CA 91710 1-800-288-4002 www.jacuzzi.
English Espree™ Bathtub Series Page 2 www.jacuzzi.
Espree™ Bathtub Series Contents........................................................................................................................................................................... 3 Product Information.......................................................................................................................................................... 3 Safety instructions................................................................................................................
Espree™ Bathtub Series English Safety Instructions INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. This is a professional grade product. A knowledge of construction techniques, plumbing and electrical installation according to codes are required for proper installation and user satisfaction. We recommend that a licensed contractor perform the installation of all Jacuzzi® Luxury Bath products. Our warranty does not cover improper installation related problems.
Espree™ Bathtub Series WARNING: Do not operate this unit without the guard over the intake for the circulation pump (suction cover/strainer). Caution: This equipment is intended for indoor use only. Install the equipment in accordance with these instructions. Use supply wires that are suitable for 167°F (75°C), including the temperature rating of the supply conductors to be used.
Espree™ Bathtub Series English Operational Safety Instructions WARNING: Risk of hyperthermia and possible drowning! Do not use a hydromassage bathtub equipped with a heater immediately following strenuous exercise. WARNING: Risk of electrical shock! • Do not operate hydromassage system unless the bath is filled with water to at least 1-2˝ (25-51 mm) above the highest jet. • Do not immerse the control panel by overfilling the bath.
Espree™ Bathtub Series Warning: The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia. People using medications or having an adverse medical history should consult a physician before using a hydromassage bathtub equipped with a heater. Warning: Do not tamper with user-operated controls or such devices. Warning: Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturers.
Espree™ Bathtub Series English Introduction The drain/overflow of the bath extends below the bottom of the bath. Please refer to the “Technical Specifications” section for dimensions and rough-in information. FLUSH TO THE WALL Tile The floor structure beneath the bath must be able to support a total weight of bath, water, and bather. Refer to the table under total weight for your model.
Espree™ Bathtub Series Tile Tile Tile Adhesive Tile Adhesive Cement Board Cement Board Wood Stud Mounting Screws Mounting Screws Wood Stud Flange Flange 1˝ x 4˝ (not for support) Caulking Caulking Flange Flange Wood Stud Wood Stud Shim Shim The shims may be used to tighten and secure any remaining gaps between the flange and the stud. Undermount Installation Options The undermount allows for the opportunity to be flexible in the design and location of the bathtub.
Espree™ Bathtub Series Inspection and Testing English Visual Inspection XX Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only. YY Inspect the shell and bathtub components.
Espree™ Bathtub Series Framing and Support Frame out the space where the bathtub is to be located. The following should be taken into consideration when preparing the area: • • • • • • • English A Technical Specifications section has been included with in this manual. The Technical Specifications section will contain pertinent information regarding your Jacuzzi Luxury Bath product. Common Access Locations Dimensions provided on rough-in diagrams are nominal.
Espree™ Bathtub Series English Electrical Connections Risk of electric shock. Connect only to a circuit protected by a GFCI. When using electrical products, basic precautions should always be followed: • • Always follow local building and electrical codes. Grounding is required. The unit should be installed and grounded by a qualified electrician. A heater comes standard on all Espree™ corner bath models. Reset Test Two separate GFCI protected circuits are required.
Espree™ Bathtub Series On the 6060 with integral skirt, one junction box has been provided for the pump/motor. The motor is bonded to the junction box at the factory. To access, remove skirt access panel. 6060 Corner Unit Bonding A separate 120 VAVAC, 15 AMP dedicated circuit with GFCI protected outlet (commercially available) is required for heater and is to be installed in a junction box. The junction box is to be hard wired.
Espree™ Bathtub Series Drop-in Installation English Before you begin your installation, please read the following: • • • • Observe all local and building codes. Determine which tools will be used during the installation. Additional bathtub drain parts and plumbing are commercially available at plumbing and hardware stores. Drain/Overflow rough-in information is included with your bathtub in the installation instruction manual. Complete the bathtub surround installation.
Espree™ Bathtub Series ^^ Install the unit, inserting the motor/pump end first, lowering the bathtub into the opening as shown in the illustration. DO NOT use plumbing fixtures or lines to lower the unit. Allow the bathtub to rest on the supports.
Espree™ Bathtub Series 3-Wall Alcove Installation English XX Install the drain/overflow according to the Cement Board manufacturer’s instructions. Refer also to the Technical Specifications section. Watertight installation of the drain is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi Luxury Bath warranty of this product. YY Install the faucet at this time. It is recommended that the faucet be installed by a qualified plumber.
Espree™ Bathtub Series To avoid dulling and scratching the surface of the bathtub, never use abrasive cleaners. For most soiled surfaces, a mild liquid detergent and warm water is sufficient. The following is also recommended: Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbed with detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as they will damage the bathtub’s surface.
Espree™ Bathtub Series English Rapdheat™ Operation Once the heater is installed and the whirlpool pump is operating, the heating function is totally automatic. The heater will help maintain the temperature of the water in the bath. The heater is designed to help maintain the temperature of the bath water once the water is added at the desired temperature level. It does not replace the need to have adequate hot water supply for the filling of the bath.
Espree™ Bathtub Series To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be cleaned regularly. For best results, however, we recommend that you clean your whirlpool bathtub after each use using, Systems Clean™, our exclusive two-part plumbing system cleaner made specifically for whirlpool bathtubs. Systems Clean™ is available through an authorized Jacuzzi Whirlpool Bath Distributor or by calling us direct at 1-800-288-4002.
Espree™ Bathtub Series Troubleshooting Procedures English PROBLEM PROBABLE CAUSES REMEDY No power to pump/motor Pump/motor not plugged in Reset GFCI Insert plug securely into outlet Unsure that the tubing used to activate the pump/motor is tightly secured to the bottom of the ON/OFF control pad and to the AIR switch on back of the motor.
Technical Specifications Specifications - Rectangular (Right Hand and Left Hand) L W 2" (51 mm) H (Motor) SIDE VIEW L (25.
Espree™ Bathtub Series English Specifications - Corner (Right Hand and Left Hand) 2" (51 mm) FRONT VIEW H SIDE VIEW ESPREE 6060 A B 1" (25.
Espree™ Bathtub Series Roughing-In Reference *60" Motor English 18" x 4" 36" 12" H x 18" L Service Access 14'' x 4'' 42" 18" 12" H x 18" L Service Access 21" 60" Motor Opt. Service Access 15- 7 Opt. Service Access (Left hand only) *60" 21" 12" H x 18" L Service Access 14- " x 4" Motor 32" 10- " 2" 2" (Left hand only as shown) ESPREE 6036 *60" ESPREE 542 Bm 16" 16 " 12" H x 18" L Service Access 2" 14'' x 4'' Motor 42" 2" Opt. Service Access (Left hand only) Opt.
Espree™ Bathtub Series Roughing-In Reference 21" 72" 18" 18" x 4" 18" x 4" 36" 12" H x 18" L Service Access 42" 12" H x 18" L Service Access English *72" Motor Motor Opt. Service Access Opt. Service Access 2" 2" (Left hand only as shown) (Left hand only as shown) ESPREE 7236 ESPREE 7242 60" Opt. Service Access Service Access Opt. Service Access 60" 14" x 4" Motor 3" 8- 15 16" 15 16 Service Access Motor Opt. Service Access Opt.
Espree™ Bathtub Series English Cut Outs Drain Drain 90ϒ 90ϒ 90ϒ - " 6 1- 1 1 22 " 6 11 1 - 1 16 22 6 11 1 -1 Overflow Motor 22 90ϒ Overflow " Motor " 22 ESPREE 6060 WITHOUT SKIRT, RIGHT HAND ESPREE 6060 WITHOUT SKIRT, LEFT HAND 58" 4" 2" DRAIN 30" ESPREE 6032 DROP-IN CUTOUT Installation and Operation www.jacuzzi.
Espree™ Bathtub Series English Authorized Service If you need a referral for a service company near you, or need assistance with operation or maintenance-related questions, please call our Service Support Department at 1-800-288-4002. Visit our web site at http://www.jacuzzi.com/ for products, services, and an online copy of these Installation and Operation Instructions. When requesting service or technical assistance please have available both the model and serial number of your unit.
Limited Lifetime Warranty Espree™ Bathtub Series Warranty on Jacuzzi Luxury Branded Baths for the Comfort, Comfort Plus, Pure Air®, Luxury, Salon™ Spa, and Pure Air® II Collections Jacuzzi Luxury Bath (the “Company”) offers the following expressed limited lifetime warranty to the original purchaser of any Jacuzzi® Luxury Bath products provided in the Company’s Comfort, Comfort Plus, Pure Air®, Pure Air® II, and Luxury™ collections ("Bath") who purchases the Bath for personal or single family residential u
RETURN OF WARRANTY REGISTRATION Espree™ Bathtub Series English Español To register your product, please go to our web-site Jacuzzi.com, click on Bath and Showers, then select ONLINE WARRANTY REGISTRATION from the top of the page. You will then be prompted to enter your product Serial Number followed by your warranty registration information. Or you may also register by completing the registration below and mailing it to Jacuzzi at the address provided below.
