User Manual

38
 Use the antenna connected to port 1 as it is used as the default antenna for writing
tags
Write an ID to a Tag
1. Click the Write link on the navigation menu. The Write page appears.
2. In the middle pane, type or paste a hexadecimal tag id to be written to the tag in the
RQL statement after tag_id=0x . For example: 16 hex characters for 64-bit tags, 20
characters for 96-bit tags, etc.)
3. Click the Make Update button. A query designed to write the highlighted data to the
tag appears in the center pane.
4. Place the tag 0.3-0.6m (1-2ft) from the antenna connected to port 1. Verify that no
other tags are in the antenna’s field.
5. Click the Submit Query button to write the data. If the write was successful, the new
tag id appears in the bottom pane.
Search For a Tag
1. Display the Write page (click the Write link on the navigation menu).
2. Click the Make Select button. A query designed to read data from the antenna
connected to port 1 appears in the center pane.
3. Place the tag to be read within the detection zone of the antenna.
4. Click the Submit Query button to find the selected tag type. Query results appear in the
bottom pane. Note that the query can be run only once, unlike on the Query page.