User Manual
Table Of Contents
- Contents
- Mercury4 & 5 Reader User Guide
- Appendix A: Mercury4 Antenna Information
- Appendix B: M5 Antenna Information
39
Settings Page
Use the Modify Settings page to change RFID protocol, network and reader security settings.
The page is divided into five sections:
RFID Protocol Settings on page 42
Network Settings on page 43
Network Settings: All Interfaces on page 43
Network Settings: Ethernet Interface on page 44
Boot Option Settings on page 45
Security Settings on page 46
Changing these parameters changes the reader’s settings used on startup. RFID protocol
settings, boot options and network settings can be modified. Care must be taken to use correct
values or you might be unable to connect the reader without restarting into safe mode.
Note
Do not disconnect power until the save process is complete. Note that new RFID,
network and security settings take effect after saving. Boot-related options are
saved but DO NOT take effect until the reader is restarted (see Restarting the
Reader). Therefore, to ensure that all new settings take effect. it is recommended
that you restart the reader whenever reconfiguring and after saving the new
settings.