User Manual

42
RFID Protocol Settings
The RFID protocol settings take effect immediately on the reader upon saving them. A restart is
not required. The Default RQL Query runs continuously at startup and thus a change to this
setting requires a restart of the reader.
RFID Protocol Settings
Setting Description
UHF Power (dBm) This field contains the UHF Output power measured in dBm. This setting must
be adjusted carefully to comply with FCC regulations. See the section
Setting
the Reader RF Power.
EPC1 Tag ID
Length
These radio buttons enable combined 96- and 64-bit tag support or single tag
id lengths. If the reader will only be reading 96- or 64-bit tags, select the 96-bit
or 64-bit radio button to optimize read rates.
EPC0 Search Depth This field contains the maximum number of EPC0 tags to be singulated on each
query.
Gen2 Init Q
This field contains the initial value of
Q when a search on a GEN2 target
begins for the first time.
Gen2 DRM On
This field controls whether the Dense Reader Mode (DRM) is on or off when
performing Generation 2 searches.
Default RQL Query This field contains the initial query that is run continuously when reader starts
up.