User Manual

Common Error Messages
47
FAULT_MSG_INVALID_FREQ_RECEIVED (104h)
Cause
A message was received by the reader to set the frequency outside the supported range
Solution
Make sure the host does not set the frequency outside this range or any other locally supported
ranges.
FAULT_MSG_INVALID_PARAMETER_VALUE - (105h)
Cause
The reader received a valid command with an unsupported or invalid value within this command.
For example, currently the module supports two antennas, 1 and 2. If the module receives a
message with an antenna value other than 1 or 2, it returns this error.
Solution
Make sure the host sets all the values in a command according to the values published in this
document.
FAULT_MSG_POWER_TOO_LOW - (106h)
Cause
A message was received to set the read or write power to a level that is lower than the current
HW supports.
Solution
Check the HW specifications for the supported powers and insure that that level is not
exceeded. The M5e supports powers between 5 and 30 dBm. The M5e-Compact units support
power from 10 dBm to 23 dBm.