User's Guide
Table Of Contents
- THINGMAGIC M6e User Guide
- Introduction
- Hardware Overview
- Hardware Interfaces
- Digital/Power Connector
- USB Interface
- General Purpose Input/Output (GPIO)
- Power Requirements
- Special RF Power Output Requirements for the M6e-A
- Environmental Specifications
- Electro-Static Discharge (ESD) Specification
- Mounting Screw Clearance
- Assembly Information
- Antennas
- M6e Mechanical Drawing
- Authorized Antennas
- M6e-A Authorized Cables
- Firmware Overview
- New Features - Version 1.21.2
- Margin Read Support for Monza6 Tags
- NXP UCODE7 Configuration Support
- Gen2 Parameters in Metadata
- Support for Acura Gen2V2 Tags
- Support for GEN2V2 Embedded Tag Ops
- Gen2V2 Support
- Denatran Tag Support
- Configurable T4 for Gen2 Protocol
- Ability to “Read Data” Immediately After Sending a “Write EPC” or “Write Data” Command
- Decoupling Antenna Selection from AsyncOnTime
- Support for Additional Regions
- Support for Set/get Quantization Value and Minimum Frequency in Open Region
- Operational Notes
- Boot Loader
- Application Firmware
- Custom On-Reader Applications
- New Features - Version 1.21.2
- Communication Protocol
- Functionality
- Specifications
- Compliance and IP Notices
- Error Messages
- Getting Started – Development Kit and Carrier Board
- Environmental Considerations
ThingMagic M6e User Guide 40
www.JADAKtech.com
Storage Temp. -40°C to +85°C
Shock and Vibration Designed to be installed in host devices which are required to survive 5 foot drops to
concrete
Performance
Max Read Rate Up to 750 tags/second using high-performance settings
Max Tag Read Distance Over 9 meters (30 feet) with 6 dBiL antenna (36 dBm EIRP)
Specifications subject to change without notice.
1
Maximum power may have to be reduced to meet regulatory limits, which specify the combined effect of the module, antenna, cable and
enclosure shielding of the integrated product. Adequate heat sinking required to run continuously at maximum power.