User's Guide
Table Of Contents
- THINGMAGIC M6e User Guide
- Introduction
- Hardware Overview
- Hardware Interfaces
- Digital/Power Connector
- USB Interface
- General Purpose Input/Output (GPIO)
- Power Requirements
- Special RF Power Output Requirements for the M6e-A
- Environmental Specifications
- Electro-Static Discharge (ESD) Specification
- Mounting Screw Clearance
- Assembly Information
- Antennas
- M6e Mechanical Drawing
- Authorized Antennas
- M6e-A Authorized Cables
- Firmware Overview
- New Features - Version 1.21.2
- Margin Read Support for Monza6 Tags
- NXP UCODE7 Configuration Support
- Gen2 Parameters in Metadata
- Support for Acura Gen2V2 Tags
- Support for GEN2V2 Embedded Tag Ops
- Gen2V2 Support
- Denatran Tag Support
- Configurable T4 for Gen2 Protocol
- Ability to “Read Data” Immediately After Sending a “Write EPC” or “Write Data” Command
- Decoupling Antenna Selection from AsyncOnTime
- Support for Additional Regions
- Support for Set/get Quantization Value and Minimum Frequency in Open Region
- Operational Notes
- Boot Loader
- Application Firmware
- Custom On-Reader Applications
- New Features - Version 1.21.2
- Communication Protocol
- Functionality
- Specifications
- Compliance and IP Notices
- Error Messages
- Getting Started – Development Kit and Carrier Board
- Environmental Considerations
ThingMagic M6e User Guide 56
www.JADAKtech.com
FAULT_TAG_ID_BUFFER
_NUM_TAG_TOO_LARG
E
603h The module received a
request to retrieve more tags
than is supported by the
current version of the
software.
Send a test case reproducing the
behavior to rfid-
support@jadaktech.com.
System Fault Errors
Message Code Cause Solution
FAULT_SYSTEM_UNKNO
WN_ERROR
7F00h The error is internal. Send a test case reproducing the
behavior to rfid-
support@jadaktech.com.
FAULT_TM_ASSERT_FAI
LED
7F01h An unexpected internal error
has occurred.
The error will cause the module to
switch back to Bootloader mode.
When this occurs make note of
the operations you were
executing, save FULL error
response and send a test case
reproducing the behavior to rfid-
support@jadaktech.com.
Tag ID Buffer Fault Errors (Continued)
Message Code Cause Solution