User's Guide
Table Of Contents
- COPYRIGHT INFORMATION
- TECHNICAL SUPPORT AND CONTACT INFORMATION
- Introduction
- Hardware Overview
- SMT Reflow Profile
- Host Board Design
- ThingMagic M3e Carrier Board
- TBD
- Programming for ThingMagic M3e
- Upgrading the ThingMagic M3e
- Verifying Application Firmware Image
- Host-to-Reader Communication
- Reader-to-Host Communication
- CCITT CRC-16 Calculation
- Power Modes
- Federal Communication Commission (FCC) Interference Statement
- User Manual Requirement
- End Product Labeling
- End Product Labeling
- Authorized Antennas
- Antennas
- Antennas
- Both the HF antenna and the LF antenna are attached to the Carrier Board.
- The HF antenna is embedded in the PCB of the Carrier Board.
- The LF antenna is connected to the Carrier Board.
- Powering Up and Connecting to a PC
- USB/RS232
- ESD Damage Overview
- Identifying ESD as the Cause of Damaged Readers
- Common Installation Best Practices
- Environmental
ThingMagic M3e User Guide
29
4 Communication Protocol
www.JADAKtech.com
Caution: Please contact rfid-support@jadaktech.com before beginning the process of getting
regulatory approval for a finished product using the ThingMagic M3e. We can
supply documents, test reports and certifications to the test house, which will greatly
accelerate the process.
Protocol Support
The M3e module supports complex HF RFID tag interaction as well as possessing the flexibility to read
both HF and LF cards.
The HF protocols supported by M3e are mentioned below-
• ISO15693
• ISO1443A/B
The M3e supports 125 KHz and 134.2 KHz LF protocols.
5 Regulatory Support