User's Guide
Table Of Contents
- COPYRIGHT INFORMATION
- TECHNICAL SUPPORT AND CONTACT INFORMATION
- Introduction
- Hardware Overview
- SMT Reflow Profile
- Host Board Design
- ThingMagic M3e Carrier Board
- TBD
- Programming for ThingMagic M3e
- Upgrading the ThingMagic M3e
- Verifying Application Firmware Image
- Host-to-Reader Communication
- Reader-to-Host Communication
- CCITT CRC-16 Calculation
- Power Modes
- Federal Communication Commission (FCC) Interference Statement
- User Manual Requirement
- End Product Labeling
- End Product Labeling
- Authorized Antennas
- Antennas
- Antennas
- Both the HF antenna and the LF antenna are attached to the Carrier Board.
- The HF antenna is embedded in the PCB of the Carrier Board.
- The LF antenna is connected to the Carrier Board.
- Powering Up and Connecting to a PC
- USB/RS232
- ESD Damage Overview
- Identifying ESD as the Cause of Damaged Readers
- Common Installation Best Practices
- Environmental
ThingMagic M3e User Guide
48
www.JADAKtech.com
Development Kit Hardware
Components included in the kit:
• ThingMagic M3e soldered onto carrier board
• Power/interface developer’s board
• One USB cable
• One HF antenna embedded in the Carrier Board
• One LF Antenna Coil assembly that connects to the Carrier Board.
• One 9V power supply
• International power adapter kit
• Sample tags
• Quick Start Guide below
Formatted: Not Strikethrough
Formatted: Font color: Custom Color(RGB(35,31,32)),
Not Strikethrough
Formatted: Font color: Custom Color(RGB(35,31,32)),
Not Strikethrough
Formatted: Not Strikethrough
Formatted: Not Strikethrough