Instructions / Assembly

Jade Bathrooms Products Inc.
11900 J.J. Joubert, Suite B, Rivière des Prairies, Québec, Canada, H1E 7E7
Tel: [phone] • Fax: [phone] • www.jadebath.com
Customer Service: 866-333-0555
2
Capri 1018
Installation Procedure
• Use liquid detergent & soft cloth to clean bathtub regularly.
• Do not use detergent containing acetone or ammonia. Also do not use abrasives or
detergents containing chemical solvent or solid particles; it could easily scratch.
• To repair scratches in the acrylic, use #1500 wet polishing sand paper to grind. Subse-
quently, use a cloth with car wax to polish the scratch to obtain a glossy finishing.
• To remove joint compound, use a plastic or wood spatula wrapped with a damp cloth. Do
not use any metal tool or brush.
• If a rubber mat is used inside the tub, it is necessary to remove it after every bath. Other-
wise, potential damage could be caused and will not be covered by warranty.
GENERAL TUB MAINTENANCE & REPAIR
CONGRATULATIONS!!!
Now your Tub should be ready for use! Enjoy your bath!
If you have any questions, feel free to contact us
at the Customer Service: 866-333-0555
DRAIN & OVERFLOW SYSTEM
PLEASE NOTE: The Drain & Overflow System is already
installed. The following illustration is for informational
purposes only.
TUB INSTALLATION
1) Prepare the piping to connect to the drain.
(Professional Installation Recommended)
2) Verify the fitting to connect the drain.
3) Once the pipe under the floor is ready put
the tub in place and connect underneath.
4) Proceed to finalise piping connections.
Free Standing Tub