User's Manual

RECALLING A MEMORISED POSITION
Press the appropriate memory preset button
(for the driver’s settings, MEMORY 1 (2 or 3)
SETTINGS RECALLED will be displayed in the
Message centre).
RESTRICTED SEAT TRAVEL
If an obstruction is encountered while the seat
is in motion, the seat will stop moving and
further movement will be restricted until reset.
To reset the seat:
1.
Remove the obstruction.
2.
Adjust the seat to the point where
movement is restricted.
3.
Press and hold the switch for at least 2
seconds to override the restriction.
SITTING IN THE CORRECT POSITION
The driver and front passenger must
not ride with the seat fully reclined.
Do not adjust the seat while the vehicle
is moving.
The seat, head restraint, seat belt and airbags,
all contribute to the protection of the user.
Correct use of these components will give you
greater protection, therefore you should observe
the following points:
1.
Sit in an upright position, with the base of
your spine as far back as possible. To
achieve optimum benefit of the seat belt in
the event of an accident, do not recline the
seat excessively.
2.
Do not move the driver's seat too close to
the steering wheel. Ideally, a minimum
distance of 254 mm is recommended
between the breastbone and the steering
wheel airbag cover. Hold the steering wheel
in the correct position with your arms
slightly bent.
3.
Adjust the head restraint so that the top of
the head restraint is above the centre line
of the head.
4.
Position the seat belt so that it is mid-way
between your neck and your shoulder. Fit
the strap tightly across your hips, not
across your stomach.
Make sure that your driving position is
comfortable and enables you to maintain full
control of the vehicle.
TOUCH SCREEN SEAT COMFORT AND
ADJUSTMENT
The front and rear seat heating or cooling
temperature and the driver's remote adjustment
of the seating positions, can all be controlled
from the front Touch screen. See 141, SEAT
COMFORT AND ADJUSTMENT.
15
Front seats
R
FOR REFERENCE ONLY
24.07.2015