User's Manual

REAR LAMP REMOVAL
Removal of the rear lamp unit should
only be attempted by a qualified
technician. If in doubt, consult your
Retailer/Authorised Repairer.
HIGH LEVEL BRAKE LAMP
REPLACEMENT
Removal of this lamp unit should only
be attempted by a qualified technician.
If in doubt, consult your Retailer/
Authorised Repairer.
WIPERS SERVICE POSITION
Note: The Smart key must remain in the vehicle
while the wiper blades are replaced.
To prevent damage to the bonnet, make
sure that the wiper arms are in the
'service' position before lifting the wiper
blades away from the windscreen.
Before changing a wiper blade, the wiper arms
must be set in the 'service' position as follows:
1.
Make sure the ignition is switched off.
2.
Switch the ignition on, then off again.
3.
Immediately pull the wiper/washer control
towards the driver (as if to command a
single wipe), hold this position while
switching the ignition on again.
The wipers will move to their service
position.
4.
When the new parts have been fitted, switch
the ignition off. This will return the wipers
to the park position.
Note: Fit only replacement wiper blades that are
identical to the original specification.
SUNROOF RESET
If the battery is disconnected, or the power
supply is interrupted, while the sunroof is
partially open it will need to be reset.
Once the power supply is restored, reset the
sunroof as follows:
1.
Switch the ignition on.
2.
Fully close the sunroof.
3.
Press the front of the sunroof switch, and
hold for 45 seconds.
4.
After 45 seconds the sunroof will begin to
move. Keep the front of the switch pressed
until the sunroof and the roof blinds have
fully opened, then closed.
5.
Once the open/close cycle has completed
and the sunroof has stopped moving,
release the switch.
The sunroof can now be operated as normal.
WINDOW RESET
The windows will need to be reset if the battery
is disconnected, becomes discharged, or the
power supply is interrupted.
Once the power supply is restored, reset the
windows, as follows:
1.
Make sure that the engine is running.
2.
Close the window fully, and release the
switch.
3.
Lift the switch to the close position and hold
for 2 seconds.
4.
Release the switch.
5.
Repeat the lift and release procedure (steps
3 and 4) twice more.
6.
Open the window fully.
7.
Lift and release the switch to check the
One-touch window operation, see 61, ONE-
TOUCH WINDOW OPERATION.
8.
Repeat the procedure on each window.
197
Maintenance
R
FOR REFERENCE ONLY
24.07.2015