User's Manual

When selected, the last known tyre pressures
will be displayed, alongside the recommended
cold tyre pressures (in brackets).
Note: If any of the wheels or tyres have been
removed, the displayed tyre pressures may not
be valid. Drive the vehicle for at least 15 minutes
in order to re-calibrate the system.
RECOMMENDED TYRE PRESSURE
LOOK-UP
The Instrument panel can be used to display
the recommended cold tyre pressures for your
vehicle. The tyre pressure look-up table can be
accessed via Tyre Pressures and the
Recommended Pressures menus. See 41,
INSTRUMENT PANEL MENU.
Depending on the specification of your vehicle,
a number of different values may be displayed
to reflect different driving conditions, for
example, high speed driving or for a heavily
laden vehicle.
TEMPORARY-USE SPARE WHEEL AND
TYRE CHANGE
If the temporary use spare wheel is fitted, the
system will automatically recognise the change
in wheel positions. After approximately 10
minutes of driving above 25 km/h (18 mph),
the message FRONT[REAR] RIGHT[LEFT] TYRE
PRESSURE NOT MONITORED will be displayed,
accompanied by illumination of the warning
lamp.
The warning lamp will first flash and then
illuminate continuously. Extended use of the
temporary use spare wheel will trigger the
message TYRE PRESSURE MONITORING
SYSTEM FAULT.
This TPMS display sequence will be activated
at every ignition cycle until the temporary spare
wheel is replaced by a full-size road wheel with
a TPMS sensor fitted.
Note: If in use, always replace the temporary
spare wheel before having a TPMS fault
investigated.
232
Tyre pressure monitoring system (TPMS)
L
FOR REFERENCE ONLY
24.07.2015