User's Manual

LIGHTING CONTROL
1.
With the headlamps on, push the switch
away from the steering wheel to select high
beam. The blue warning indicator in the
Instrument panel will illuminate.
2.
Pull the switch towards the steering wheel
and release to flash the high beam on and
off. The high beam will remain on for as
long as the switch is held.
3.
Side lamps.
4.
Low beam.
5.
AUTO: When ambient light fades, the side
lamps and headlamps will switch on
automatically.
6.
Exit delay of 30 seconds.
7.
Exit delay of 60 seconds.
8.
Exit delay of 120 seconds.
Note: If the rotary control is in the AUTO
position there will be no exit delay and the
headlamps will extinguish when the ignition
system is switched off.
Press the headlamp button on the Smart key to
switch off the headlamps during an exit delay
period.
If the rotary control is moved to the OFF
position, with high beam still activated, both
low and high beam will be extinguished. Both
low and high beam will illuminate when the
headlamps are switched on again.
DAYTIME RUNNING LAMPS
With the rotary control in the OFF or AUTO
position, the front Daylight running lamps will
switch on automatically with the following
conditions:
• The ignition is on.
• The engine is running.
• The gear selector is in Drive (D) or Reverse
(R) - market dependent.
49
Exterior lights
R
FOR REFERENCE ONLY
24.07.2015