User's Manual

Note: The lamps remain on if the gear
selector is subsequently moved to Neutral
(N).
• The Electric Parking Brake (EPB) is not
applied (is released) - market dependent.
APPROACH LAMPS
The headlamps can be illuminated remotely for
a programmed length of time, by pressing the
headlamp button on the Smart key. See 4,
UNLOCKING THE VEHICLE. Press the button
again to switch off.
ADAPTIVE FRONT LIGHTING SYSTEM
(AFS)
Adaptive front lighting is designed to give the
driver improved visibility, using a swivelling
headlamp unit, a static bending lamp and a
cornering lamp. These lamps broaden the beam
of the headlamps when cornering in different
circumstances.
The headlamp unit swivels accordingly when
cornering, to improve light spread on bends in
the road.
Static bending lamps: The static bending lamps
operate when necessary, to provide an even
broader light spread.
Cornering lamps: At speeds up to 40 km/h (25
mph), to provide improved visibility at junctions,
the system switches on the lamp if it has
received an input from the vehicle's direction
indicator. Only the lamp on the same side as
the operating indicator illuminates. The lamp
will self cancel after 3 minutes of continuous
operation.
WINDSCREEN WIPER DETECTION
This function only operates when AUTO is
selected. The side lamps, tail lamps and
headlamps will switch on automatically if the
windscreen wipers are switched on for 20
seconds or more. Once the windscreen wipers
are switched off, the side lamps and headlamps
will automatically switch off 2 minutes later.
AUTO HIGH BEAM
This feature automatically selects and deselects
high beam, under specific conditions of road
lighting and in the absence of other vehicle’s
lights. The system is only active when the
ambient light drops below a predetermined
level.
This function is only active if the rotary control
is in the AUTO position and the lighting control
is in the central position.
The system will only activate when the vehicle's
speed exceeds 40 km/h (25 mph). The system
will deactivate when the vehicle's speed drops
below 24 km/h (15 mph).
Note: Auto high beam does not operate when
Reverse (R) gear is selected.
To manually select high beam, move the lighting
control to the high beam position, as normal.
To return to Auto high beam, move the lighting
control back to the central position.
To manually override to low beam from high
beam, pull the lighting control to the flash
position and Auto high beam will be cancelled.
To return to Auto high beam, push the lighting
control to the high beam position and then
return it to the central position.
When Auto high beam is enabled, the system
indicator will illuminate, see 47, AUTO HIGH
BEAM (GREEN).
Note: Make sure that the sensor in the rear-view
mirror is not blocked or obstructed.
50
Exterior lights
L
FOR REFERENCE ONLY
24.07.2015