User's Manual

RADIO FREQUENCY TRANSCEIVER
In some countries, the Radio Frequency (RF)
transceiver is also known as the HomeLink®
Universal Transceiver.
The RF transceiver is located in the rear view
mirror. It can be programmed to transmit the
signals of up to 3 different hand held
transmitters. These can be used to operate
garage doors, entry gates, home lighting,
security systems, or other RF operated remote
devices.
Do not use the RF transceiver with any
garage door opener that lacks the
safety stop and reverse feature, as
required by safety standards.
When programming the RF transceiver
to a garage door opener or entry gate,
make sure that the area is clear of
people and objects. This will prevent
potential harm or damage, as the gate
or garage door will activate during
programming.
This device may suffer from interference,
if operated in the vicinity of a mobile or
fixed station transmitter. This
interference is likely to affect the
hand-held transmitter, as well as the RF
transceiver.
For further information, see 59, INFORMATION
AND ASSISTANCE.
BEFORE PROGRAMMING
When programming a remote device that
may require you to press and re-press
the hand-held transmitter, unplug the
device during the programming process,
to prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter before programming. If
the remote device’s receiver is equipped with
an antenna, make sure the antenna is extended.
PROGRAMMING
To program the RF transceiver:
1.
Switch the vehicle’s ignition on.
2.
Position the hand-held transmitter 25 to 75
mm from the rear view mirror.
3.
Simultaneously press and hold the memory
button on the hand-held transmitter, and
the desired memory button on the RF
transceiver. An indicator LED, located on
the left side of the mirror, will start flashing
slowly.
4.
When the LED starts flashing quickly,
release both buttons.
To operate the remote device, press and hold
the programmed memory button on the RF
transceiver for 2 seconds. If the LED illuminates
continuously, the RF transceiver has been
programmed successfully, and the remote
device will operate.
Note: You may need to press the button on the
RF transceiver up to 3 times.
If the remote device does not operate, and the
LED flashes quickly, further programming will
be required.
These additional programming steps may
require assistance from another person.
1.
Locate the smart/learn program button on
the remote device you wish to program.
58
Garage door opener
L
FOR REFERENCE ONLY
24.07.2015