Automobile User Manual

CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
v Pin
Description
I FC15-15
IGNlTlON SWITCHED GROUND
0
FC15-17
SEAT HEATER STATUS ILHD = PASSENGER, RHD = DRIVER)
I FC15-32
IGNITION SWITCHED GROUND
I FC15-35
SEAT HEATER REQUEST ILHD = PASSENGER, RHD = DRIVER)
I FClS-41
STARTER ENGAGE REQUEST
0
FCIS-69
SEAT HEATER STATUS iLHD = DRIVER. RHD _ PASSENGER,
I FC15-80
BATTERY SUPPLY VOLTAGE
I FC15-86
SEAT HEATER REQUEST iLHD = DRIVER. RHD = PASSENGER)
Active
GROUND
GROUND
GROUND
GROUND IMOMENTARY)
GROUND (CRANKING)
GROUND
B+
GROUND ,MOMENTARYI
Inactive
Bt
Bt
B+
Bt
BC
B+
B+
BT
COMPONENTS
Component
BODY PROCESSOR MODULE
DOOR CONTROL MODULE-DRIVER
DOOR CONTROL MODULE - DRIVER REAR
SEAT CUSHION HEATERS-DRIVER
SEAT HEATER SWITCH
(CENTER CONSOLE SWITCH PACKI
SEAT MOTOR-DRIVER (RAISE, LOWER ONLY)
Connector / Type / Color
FC15,14-WAYAMPEEECiGREY
DDIO i 22.WAY FORD 2.8 TIMER, BLUE
DD, 1,22-WAY FORD 2.8 TIMER, BLACK
RDIO, 22~WAY FORD 2.8 TIMER, BLUE
RDI 1,22~WAY FORD 2 8 TlMER , BLACK
947-D, 3-WAY MULTlLOCK 070, YELLOW
CC1 ,16-WAY FORD IDC S.U , BLACK
SM,G-D, B-WAY MULTILOCK 070, GREY
Location I Access
BULKHEAD, BEHIND GLOVE BOX
DOOR CASING ,TRlM PANEL
DOOR CASING /TRIM PANEL
DRIVER SEAT
CENTER CONSOLE SWITCH PACK
DRIVER SEAT, UNDER
SEAT SQUAB HEATERS - DRIVER
9.49.D, 3WAY MULTILOCK 070, GREY
DRIVER SEAT
SWITCH PACK DRIVER SEAT iRA,SE, LOWER ONLY1
SM17-D! 16.WAY MULTILOCK 040, BLACK
DRl”ER SEAT, UNDER
RELAYS
Relay
Case Color
Connector / Color
Location / Access
SEAT HEATER RELAY-DRIVER
BROWN
SMll~Di BROWN
FRONT SEAT RELAYS, UNDER SEAT
SEAT RAISE RELAY
VIOLET
SMIB-D/VIOLET
FRONT SEAT RELAYS, UNDER SEAT
SEAT LOWER RELAY
VIOLET
SM,B-D, VIOLET
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector Type I Color
Location / Access
CA8
CA13
CA23
FCI
FC5
FC7
20.WAY MULTILOCK 070, WHITE
S-WAY MULTILOCK 070, WHITE
TO-WAY MULTILOCK 070, WHITE
&-WAY THROUGH PANEL CONNECTOR, BLACK
54.WAY THROUGH PANEL CONNECTOR, BLACK
2O~WAY MULTILOCK 070, WHITE
DRIVER ‘K POST, DOOR HARNESS GAITER
DRIVER ‘B,c’ POST, DOOR HARNESS GAITER
BELOW DRIVER SEAT
BELOW PASSENGER SIDE AIR VENT, GLOVE BOX ASSEMBLY
BELOW DRl”ER SlDE AIR VENT, COIN TRAY
ABOVE DIMMER MODULE, COIN TRAY
GROUNDS
Ground
Location I Type
CA25L
CA2SL
CCBL
EYELET (PAIR) -PASSENGER SEAT GROUND STUD
EYELET (PAIR, -DRIVER SEAT GROVND STUD
EYELET ,PAIIR) - RH FRONT BULKHEAD STUD, CABiN SlDE
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
0 output
Serial and encoded communications
C CAN (Network)
B+ Battery voltage KHz Frequency x 1000
SG Signal Ground
V Voltage (DC) MS Milliseconds
S
SCP Network
Hz Frequency MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTfFlCATlON OF COMPONENTS, RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.