Automobile User Manual

CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
v Pin
Description
IGNITION SWITCHED GROUND
SEAT HEATER STATUS (LHD = PASSENGER, RHD = DRIVER)
IGNITION SWITCHED GROUND
SEAT HEATER REQUEST ,LHD = PASSENGER, RHD = DRIVER)
STARTER ENGAGE REQUEST
SEAT HEATER STATUS ,LHD = DRIVER. RHD i PASSENGER,
BA”ERY SUPPLY VOLTAGE
SCP NETWORK
SCP NETWORK
SEAT HEATER REQUEST ILHD = DRIVER, RHD = PASSENGER)
PASSENGER SEAT CONTROL MODULE
77 Pin
Description
Active
0
SM,-1P
PASSENGER SEAT SQUAB FORE, AFT RECLINE MOTOR SUPPLY
B+
0
SM,-2P
PASSENGER SEAT SQUAB FORE/AFT RECLINE MOTOR SUPPLY
B+
0
SMl~BP
PASSENGER SEAT CUSHION RAISE/ LOWER FRONT MOTOR SUPPLY
B-
0
SMI-4P
PASSENGER SEAT CUSHiON RAISE, LOWER FRONT MOTOR SUPPLY
B-
0
SM1~SP
PASSENGER SEAT HEADREST RAISE I LOWER MOTOR SUPPLY
Bt
0
SM,-BP
PASSENGER SEAT HEADREST RAISE, LOWER MOTOR SUPPLY
B+
0
SM1~7P
PASSENGER SEAT CUSHION FORE /AFT MOTOR SUPPLY
B+
0
SM,-BP
PASSENGER SEAT CUSHION FORE /AFT MOTOR SUPPLY
Bi
I ml,-9P
PASSENGER SEAT CUSHION FORE MOVEMENT REQUEST
B-
I SMI-IOP
PASSENGER SEAT CUSHION AFT MOVEMENT REQUEST
B-
/ SMl-llP
PASSENGER SEAT CUSHlON LOWER REAR MOVEMENT REQUEST
B+
I SM,-lZP
PASSNGER SEAT CUSHION RAISE REAR MOVEMENT REQUEST
B+
I SMl~lSP
PASSENGER SEAT CUSHION RAISE FRONT MOVEMENT REQUEST
B+
/ SM,-14P
PASSENGER SEAT CUSHION LOWER FRONT MOVEMENT REQUEST
BT
I SM,-ISP
PASSENGER SEAT SQUAB AFT RECLINE MOVEMENT REQUEST
B-
I SMI-1GP
PASSENGER SEAT SQUAB FORE RECLINE MOVEMENT REQUEST
B+
I SMB-ZP
0
SM3-3P
0
SM3-4P
I SM3-SP
I SM3-6P
I SM3-BP
S
SM3-9P
S
SMB-lOP
COMMON GROUND SUPPLY
PASSENGER SEAT CUSHION RAISE, LOWER REAR MOTOR SUPPLY
PASSENGER SEAT CUSHION RAISE, LOWER REAR MOTOR SUPPLY
BATTERY SUPPLY
PASSENGER SEAT HEADREST RAISE MOVEMENT REQUEST
PASSENGER SEAT HEADREST LOWER MOVEMENT REQUEST
SCP NETWORK
SCP NETWORK
Active
GROUND
GROUND
GROUND
GROUND iMOMENTARYi
GROUND ,CRANKINGl
GROUND
Bi
2- 1600 HZ
2- 1600 Hz
GROUND iMQMENTARYi
GROUND
B+
B+
B+
Bi
B+
2 - ,600 Hz
2 - 1600 Hz
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
B+
BC
Bt
Bt
B+
B+
Br
B+
Inactive
GROUND
GROVND
GROUND
GROUND
GROVND
GROUND
GROUND
GROUND
GROUND
GROUND
GROVND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
B+
GROUND
GROUND
COMPONENTS
Component
Connector I Type I Color
Location I Access
BODY PROCESSOR MODVLE
SEAT CONTROL MODULE - PASSENGER
SEAT CUSHlON HEATERS-PASSENGER
SEAT HEATER SWITCH
(CENTER CONSOLE SWITCH PACK
SEAT LUMBAR PUMP- PASSENGER
SEAT MOTORS PASSENGER
SEAT SQUAB HEATERS-PASSENGER
sWlTCH PACK - PASSENGER SEAT
FC15,14-WAYAMPEEEC,GREY
SM,-P, 16.WAY FORD 2.8 TiMER , BLACK
SMB-Pi lo-WAY FORD 2 8 TIMER, BLACK
SM7-P ,3~WAY MULTlLOCK 070, YELLOW
CC1 ! ,&WAY FORD IDC 2”. , BLACK
SM10-P/3-WAY MULTILOCK 070 /YELLOW
344-P , B-WAY MULTILOCK 070 : GREY
SMG-Pi B-WAY MULTILOCK 070, YELLOW
SM,I-PIG-WAY M”LTlLOCK070IWHITE
SM12-PIG-WAY MULTILOCK 070,WHITE
SM13-Pi&WAY MULTILOCK 070,YELLOW
SMD-P, 3~WAY MULTlLOCK 070, GREY
SM5-Pi 16.WAY MULTiLOCK 040, BLACK
BULKHEAD, BEHIND GLOVE BOX
PASSENGER SEAT, UNDER
PASSENGER SEAT
CENTER CONSOLE SWITCH PACK
PASSENGER SEAT
PASSENGER SEAT, UNDER
PASSENGER SEAT
PASSENGER SEAT
RELAYS
Relay
Case Color
Connector I Color
Location I Access
SEATHEATERRELAY-PASSENGER
BROWN
SM,CP,BRDWN
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector
Type I Color
Location / Access
CA27
,&WAY MULTILOCK 070, WHITE
BELOW PASSENGER SEAT
FC1
54.WAYTHROUGH PANEL CONNECTOR, BLACK
BELOW PASSENGER SiDE AIR VENT, GLOVE BOX ASSEMBLY
FC5
54.WAY THROUGH PANEL CONNECTOR, BLACK
BELOW DRIVER SIDE AIR VENT, COlN TRAY
FC7
?&WAY MULTiLOCK 070, WHITE
ABOVE DIMMER MODULE, COIN TRAY
GROUNDS
Ground
Location I Type
CA25
CA2SL
CCPL
EYELET (PAIR) - PASSENGER SEAT GROUND STUD
EYELET IPAIR) - DRIVER SEAT GROUND STUD
EYELET (PAlRi - RH FRONT BULKHEAD STUD, CABIN SIDE
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
B+ Battery voltage
KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC)
MS Milliseconds
SG Signal Ground
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation, THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.