Automobile User Manual

CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
77 Pin
Description
IGNITION SWTCHED GROUND
SEAT HEATER STATUS ,LHD = PASSENGER, RHD = DRIVER)
IGNITION SWITCHED GROUND
SEAT HEATER REQUEST (LHD = PASSENGER, RHD = DRIVERI
STARTER ENGAGE REQUEST
SEAT HEATER STATUS (LHD = DRIVER, RHD = PASSENGER)
BATTERY SVPPLY VOLTAGE
SEAT HEATER REQUEST (LHD = DRIVER, RHD = PASSENGER)
Active
GROUND
GROUND
GROUND
GROVND iMOMENTARY,
GROUND (CRANKING)
GROUND
B+
GROUND (MOMENTARYI
Inactive
B+
B+
B+
B+
B+
Br
Bt
B+
COMPONENTS
Component
Connector I Type / Color
Location / Access
BODY PROCESSOR MODULE
SEATCVSHION HEATERS-DRIVER
SEAT CUSHION HEATERS-PASSENGER
SEAT HEATER SWITCHES
(CENTER CONSOLE SWITCH PACK,
FC15, ICWAYAMPEEECIGREY
%,7-D, S-WAY MULTILOCK 070,YELLOW
SM7-P, B-WAY MULTILOCK 070, YELLOW
CC,, 16.WAY FORD IDC S.U , BLACK
BULKHEAD, BEHIND GLOVE BOX
DRIVER SEAT
PASSENGER SEAT
CENTER CONSOLE SWITCH PACK
SEAT SQVAB HEATERS - DRIVER
SEAT SQUAB HEATERS PASSENGER
SMS-D, 3.WAY MULTlLOCK 070, GREY
DRIVER SEAT
SMS-P, 3-WAY MULTILOCK 070, GREY
PASSENGER SEAT
RELAYS
Relay
Case Color
Connector I Color
Location / Access
SEAT HEATER RELAY-DRIVER
SEAT HEATER RELAY- PASSENGER
BROWN
BROWN
SM14-D, BROWN
SM,h-Pi BROWN
FRONT SEAT RELAYS, UNDER SEAT
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector Type I Color
Location / Access
CA23
,&WAY MULTlLOCK 070, WHITE
BELOW DRIVER SEAT
CA27
IO-WAY MULTlLOCK 070, WHITE
BELOW PASSENGER SEAT
FC1
54.WAY THROUGH PANEL CONNECTOR, BLACK
BELOW PASSENGER SIDE AIR VENT, GLOVE BOX ASSEMBLY
FC5
54.WAY THROUGH PANEL CONNECTOR, BLACK
BELOW DRIVER SIDE AIR VENT, COIN TRAY
FC7
PO-WAY MULTlLOCK 070 /WHITE
ABOVE DIMMER MODULE, COIN TRAY
-
GROUNDS
Ground
Location / Type
CCBL
CA25L
CAZGL
EYELET iPAW - RH FRONT BULKHEAD STUD, CABIN SIDE
EYELET iPAlR) -PASSENGER SEAT GROUND STUD
EYELET (PAIR) DRIVER SEAT GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications
0 output
B+ Battery voltage
C CAN (Network)
KHz Frequency x 1000
SG Signal Ground
V Voltage (DC) MS Milliseconds
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS. RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.