User Manual

EN 3
SET UP
USE
CHARGING YOUR EARPHONES
The “Live Fast” earphones are powered by a
rechargeable battery. The earphones come pre-
charged; however, for optimal play time, make sure to
charge before rst use.
A – Unwrap the charging cable and plug the micro
USB end into the charging port on the earphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for your
cell phone or pick one up next time you’re at the store.
C – When the LED ashes red, it indicates that the
battery is low and it’s time to plug in and recharge.
Charge for about 2 hours to get up to 12 hours of play
time; while charging, the light will stay solid red. Once
fully charged, the light will turn off.
2hrs 12hrs
0000
...0.5s
...3s
0000
Live Fast
Live
Fast
...3s ...3s
...0.5s ...0.5s
A – TURN ON YOUR EARPHONES
Long press the “play/pause” button for 3 seconds to
turn on your earphones.
B – CONNECTING TO A DEVICE
Once turned on, the earphones will immediately search
for a device to pair to; the LED will blink red and blue
alternately. Enable Bluetooth on your device. From the
Bluetooth menu, select “Live Fast.” When the device
and Live Fast are connected, you will hear a tone and
the LED will turn solid blue.
Once paired, your device and earphones will nd each
other every time, as long as your device’s Bluetooth is
on. If you’re connecting to a computer, you may have
a few more steps on that end. You’ll have to get that
information from the computer company.
Depending on your device, you may be prompted to
enter a pairing code. If so, use “0000” as the code.
Holding down the “X” and “O” buttons at the same
time, for 5 seconds, will disconnect a paired device.