Use and Care Manual

ManualsBrandsJameson ManualsKitchen50 Watt Fluorescent Stringable Light

• Plug individual light into appropriate power source. Additional lights can be

plugged into individual lights to form a “string” of lights, all of which will operate

independently. You can safely connect up to 30 lights.

• Lights include adjustable height hanging straps with velcro closure for mounting

to tent supports.

• EMI Hardened Lights include blackout lter for light discipline, allowing output to

be reduced by up to 85%.

• Push button on/off switch is located on light’s handle.

Since 1956

OPERATING INSTRUCTIONS

Warranty

Jameson products carry a warranty against any defect in material and workmanship for a period of one year from date of shipment unless failure is due to

misuse or improper application. Jameson shall in no event be responsible or liable for modications, alterations, misapplications or repairs made to its products

by purchaser or others. This warranty is limited to repair or replacement of the product and does not include reimbursement for shipping or other expenses

incurred. Jameson disclaims any other express or implied warranty.

WWW.JAMESONLLC.COM

Clover, SC

Summary of content (2 pages)

PAGE 1
OPERATING INSTRUCTIONS Since 1956 • Plug individual light into appropriate power source. Additional lights can be plugged into individual lights to form a “string” of lights, all of which will operate independently. You can safely connect up to 30 lights. • Lights include adjustable height hanging straps with velcro closure for mounting to tent supports. • EMI Hardened Lights include blackout filter for light discipline, allowing output to be reduced by up to 85%.
PAGE 2
RELAMPING INSTRUCTIONS Since 1956 Use Replacement Light Kit # 31-1-50 31-502SK-IP 31-5004M-IP 1. Disconnect from power source. 2. Remove wire/cable tie from smaller end cap located opposite handle. Do not remove handle. Disconnect From Power Source Before Relamping Wear Hand and Eye Protection 3. Remove strain relief nut and sleeve from strain relief then remove end cap by gently prying off tube with a screwdriver or similar tool. Do not loosen jam nut. 4.