User Manual

E-10
Recording a File
Before recording , you can enable the VOX function (Voice Activate Recroding) for automatic
record. You can go to « VOX setting » in the recording menu and select you desire VOX level.
When record button is pressed and the input signal from Microphone/Line-In reaches the VOX
level, recording will start automatically.
Preparing for recording
At recorder mode ,you may select a desired file folder
by "A-B¨ key , and if VOX is enabled, VOX will
appear on LCD.
Press the REC/STOP button HR-5 will enter a
pre-recording status and the REC record
indicator will blink.
Current input level, recording status (bitrate,
resolution, Mono/Stereo) are then shown on
LCD.
Recording File
Then you can turn the REC Level knob to adjust
the input level.
Input level, recording status (bitrate,
resolution, Mono/Stereo), File name are shown
on the LCD.
 If the L/R Peak indicator blinks ,it means the input
level is too high ,please turn the REC level knob to lower
input level in order to avoid unwanted distortion.
Then press REC/STOP or ERASE/PAUSE key to start recording
However ,if you press Mode key ,it will cancel recording to return to recorder mode .
You can pause the recording by pressing ERASE/PAUSE key . And then
REC indicator will flash,and press again to resume recording.
To Stop recording, you can press REC/STOP and the file will be stored in
the internal memory or SD card.
Note : There are three recording inputs (Internal Mic ,External Mic ,
Line in ) ,and the sign will display on LCD , current recording source will be
displayed on the LCD screen.