JSS4-TS WARNING: Improper installation could result in damage to the amplifier. Read all instructions before installation.
Introduction Your JSS4-TS speaker selector allows simultaneous operation of up to 4 pairs of 8 Ohm speakers. Automatic load protection circuits assure that the amplifier will always see a load of 4 Ohms or higher no matter what combination of speaker is turned ON. The built-in protection circuit operates with switch pairs, permitting hookup choices for maximum power to your most frequently used speakers (up to 2 pairs). More information will be found under INSTALLATION below.
Connection To make a connection, strip about ¼in of insulation from the end, twist any loose strands together tightly so that no loose end sticks out to cause problems with short circuits. Make the connection by unscrewing the binding post counterclockwise and exposing the wire hole. Insert the stripped wire end into the wire hole and tighten the binding post by turning it clockwise.
The scope of the warranty The warranty period will come into force as from the purchase date stated on the invoice. The warranty will apply for the following period of time: 2 years for electronics (power supply, amplifier, etc.) 7 years for other parts (cabinet, speaker units, etc.) In case of warranty inquiries, please contact your dealer. In case of request for service under warranty, please enclose your original receipt.
