User's Manual

Janam XG.abg Quick Start Guide

Getting Started

C. CHARGING THE BATTERY

Important Note: The main battery charges the backup battery in the device. Once the main battery is fully charged,

do not remove it from the unit for 24 hours. During this period, the device cannot maintain any user data if the

battery is removed.

To charge the battery using the USB Cable or Serial Cable:

1. Connect the power supply to the USB or serial cable.

2. Connect snap-on end of USB or serial cable to syncing/charging connector at the bottom of device (Hardware

Overview #10) making sure the JANAM logo on the connector faces front.

3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that are

easily reached with the length of supplied power cable.

To charge the battery using the Single-Slot or Four-Slot Cradle:

1. Connect the power supply to the cradle.

2. Connect the line cord to the power supply.

3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that are

easily reached with the length of supplied power cable.

4. Place the device in cradle. The LED will illuminate to conﬁ rm connection (orange indicates charging, green

indicates fully charged and red indicates fault).

5. The battery is fully charged in approximately 5 hours.

6. For Single-Slot cradle only: Charge a spare battery by placing the battery in the spare battery well with

connectors lined up. An LED will illuminate to conﬁ rm connection.