Quick Start Guide

XG4 Series Quick Start Guide
Page 6
Janam Technologies LLC
Getting Started
Important Note: The main (removable) battery charges the internal backup battery with or without an external
power source.
Caution: All user data will be lost if the main battery is removed before the internal backup battery is properly
charged. It is recommended you check that the backup battery capacity is at 100% prior to removing the main
battery. To do this, access Settings-> Battery. It is also recommended that you first suspend the device prior to
removing the main battery.
A. INSTALL THE BATTERY
1. Place the battery with the label side facing down.
2. Slide the battery into the compartment.
3. Firmly push the battery into place.
B. CHARGE THE BATTERY
To charge the battery using the USB Cable:
1. Connect the power supply to the USB cable.
2. Open the cap of USB-C port and connect USB cable to USB-C port.
3. Plug in the power supply.
Use only easily accessible wall outlets that are easily reached with the length of supplied power cable.
To charge the battery using a Cradle Kit:
1. Connect the power supply to the cradle.
2. Plug in the power supply.
Use only easily accessible wall sockets that are easily reached with the length of supplied power cable.
3. Place the device in cradle. The LED on the device will illuminate to confirm connection.
4. The standard capacity battery is fully charged in approx. 4 hours.