Quick Start Guide

XG4 Series Quick Start Guide
Page 9
Janam Technologies LLC
Regulatory
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
Body-worn Operation
This device was tested for typical bodyworn operations with the Front & back of the device
kept 0.59 inches (1.5cm) between the user’s body and the Front & back of the device. To
comply with FCC RF exposure requirements, a minimum separation distance of 0.59 inches
(1.5cm) must be maintained between the user’s body and the Front & back of the device. Any
beltclips, holsters, and similar accessories containing metallic components may not be used.
Body-worn accessories that cannot maintain 0.59 inches (1.5cm) separation distance
between the user’s body and the Front & back of the device, and have not been tested for
typical body-worn operations may not comply with FCC RF exposure limits and should be
avoided.